Adjustments
CAUTION
Never install or work on the cutting units or lift
arms with the engine running. Always stop en-
gine and remove key first.
Height--of--Cut Adjustment
IMPORTANT: This cutting deck often cuts approxi-
mately1/4inchlowerthanareelcuttingunitwiththe
same bench setting. It may be necessary to have
theserotary cutting deck’sbench set1/4 inchabove
that of reels cutting in the same area.
2
3
NOTE: Check carrier frame position before adjusting
height--of--cut (See Carrier Frame).
4
1
1.
Lower cutting deck to ground, stop engine, and re-
move key from ignition switch.
30
(41
ft--lb
N--m)
2.
bracket to height--of--cut plate (front and each side).
Loosen cap screw securing each height--of--cut
3.
4.
5.
install spacer into designated height--of--cut hole and
slot.
Beginning with front adjustment, remove cap screw.
While supporting deck chamber, remove spacer.
Move deck chamber to desired height--of--cut and
Figure 1
1.
2.
Height--of--cut bracket
Height--of--cut plate
3.
4.
Spacer
Cap screw
6.
spacer and install cap screw finger tight.
Position tapped height--of--cut plate in line with
7.
8.
Repeat steps 4 -- 6 for each side adjustment.
Tighten all three cap screws to 30 ft--lb (41 N--m).
Figure 2
NOTE: Adjustments of more than 1 1/2 inch may re-
quire temporary assembly to an intermediate height to
prevent binding of the deck chamber.
Groundsmaster 3500--D
Page 7 -- 5
Cutting Units (Rev. D)
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 3500 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |