Carrier Frame
The front and rear cutting units require different mount-
ing positions on the carrier frames.
2
Front Carrier Frame
1.
range, the front cutting units should be mounted in the
lower front mounting holes (Fig. 30) of the carrier frame.
For heights of cut in the 3/4 to 3 inch (1.9 to 7.6 cm)
NOTE: This permits more up travel of the cutting decks
relative to the tractor when approaching quick uphill
changes in terrain. It does, however, limit the clearance
of the cutting deck to carrier when cresting sharp knolls.
1
3
2.
For heights of cut in the 2 1/2 to 4 inch (6.4 to 10.2
cm) range, the front cutting units should be mounted in
the upper front mounting holes (Fig. 30) of the carrier
frame.
Figure 30
1.
2.
Lower front mtg. hole
Upper front mtg. hole
3.
Rear mounting hole
NOTE: This increases the cutting deck to carrier clear-
ance due to the higher position of the cutting deck, but
will cause the cutting decks to reach their maximum up
travel sooner.
Rear Carrier Frame
1.
be mounted in the rear mounting holes (Fig. 30) of the
carrier frame.
For all heights--of--cut, the rear cutting deck should
Cutting Units (Rev. D)
Page 7 -- 20 Rev. E
Groundsmaster 3500--D
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 3500 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |