Toro 01088SL Rev F Service Manual Groundsmaster 3500 D Preface Publication

Procedure for Logic (Counterbalance)  Valve (LC1)
Pressure Test:
8.  Lower cutting units. Shut off engine.
Disconnect  test  gauge  with  hose  from  manifold
9.
NOTE:  If the counterbalance system is functioning, the
machine should normally settle slightly when theengine
is started.
block. Reconnect  plug to  the hydraulic  manifold port
(G2).
1.
perature by operating the machine for approximately 10
minutes.
Make sure hydraulic oil is at normal operating tem-
1
2.
lowered and off. Make sure engine is off and the parking
brake is engaged.
Parkmachineonalevelsurfacewiththecuttingunits
2
3.
Read Precautions for Hydraulic Testing.
4.
29
Remove plug from hydraulic manifold port (G2) (Fig.
and 30).
5.
port (G2).
Install test  gauge with  hydraulic hose attached  to
Figure 29
2.
1.
Hydraulic manifold
Manifold port (G2)
CAUTION
Keepawayfromdecksduringtesttopreventper-
sonal injury from the cutting blades.
1
6.
50
Start engine and move throttle to full speed (3050 +
RPM). Do not engage or raise the cutting units.
7.
250
The standard  counterbalance pressure  should be
PSIwitharange  of180to300psi.Adjustment    ofthe
Logic valve (LC1) can be performed as follows:
Note:
Do not remove the Logic valve from the hydrau-
2
lic manifold for adjustment.
Figure 30
2.
A.  Remove hex cap from logic valve (Fig. 31).
B.  Loosen locknut.
1.
Hydraulic manifold
Manifold port (G2)
3
C. To  increase  pressure setting,  turn the  adjust-
mentshaftonthevalveinaclockwisedirection.A1/8
turn on the shaft will make a measurable change in
counterbalance pressure.
2
D. To  decrease pressure  setting, turn the  adjust-
ment shaft on the valve in a counterclockwise direc-
tion. A 1/8 turn on the shaft will make a measurable
change in counterbalance pressure.
1
E.  Tighten locknut. Check counterbalance pressure
and readjust as needed.
F.  Replace hex cap to Logic valve (LC1).
Figure 31
1.
2.
Manifold assembly
Logic valve (LC1)
3.
Hex cap
Groundsmaster 3500--D
Page 4 -- 47
Hydraulic System (Rev. D)
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 256 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website