Toro 01088SL Rev F Service Manual Groundsmaster 3500 D Preface Publication

Rear Roller Service (Greasable Bearings with Retaining Ring)
Roller Disassembly (Fig. 18)
1
2
1.
2.
Remove retaining ring from both ends of roller.
Hit end of roller shaft with a soft face hammer to re-
3
4
5
move seals and bearing from one end of roller. Hit other
end of roller shaft to remove seals and bearing from oth-
er end of roller. Be careful not to drop roller shaft.
3.
Discard seals and bearings.
Roller Assembly (Fig. 18)
NOTE:  Asoftfacehammercanbeusedwiththespecial
tools listed (see Special Tools)  to assemble the roller,
however use of a press is recommended.
1.
to install inner oil seal into each end of roller tube.
Use installation tool TOR4065 and handle TOR4073
7
6
9
8
10
2.
Install ball bearings:
Figure 18
1.
2.
3.
4.
5.
Roller shaft
Outer seal
Retaining ring
Outer oil seal
Grease fitting
6.
7.
8.
9.
Washer
Inner seal
Ball bearing
Inner oil seal
10. Roller tube
NOTE:  Ball bearings have a press fit into the roller tube
and a slip fit onto the roller shaft.
IMPORTANT: If ball bearing has a seal on one side,
install bearing with seal orientated toward the out-
side of the roller.
A.  Use  tool  TOR4066  and  handle  TOR4073  to
install ball bearing into one end of roller tube.
B.  Install roller shaft from opposite end of roller. Be
careful not to damage the inner oil seals.
C. Put roller in a vertical position and support shaft
and bearing with tool TOR4067.
D. Use tool TOR4067 to install second ball bearing.
3.
4.
5.
Use tool TOR4068 to install inner seal.
Use tool TOR4069 to install outer seal.
Install retaining ring  so that side with sharp  edges
faces end of roller (out).
6.
7.
8.
Use tool TOR4071 to install outer oil seal.
Use tool TOR4067 to install washer.
Put opposite end of roller facing up and support bot-
tom end with tool TOR4067. Repeat steps 3 - 7.
9.
purpose lithium base grease to lubricate bearings until
grease appears at washer. Wipe off excess grease.
Use a hand operated grease gun and No. 2 general
Groundsmaster 3500--D
Page 7 -- 13 Rev. E
Cutting Units (Rev. D)
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 256 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website