Parking Brake Cable Replacement
Removal (Fig. 11)
7. Install center console control plate and control lever
knobs.
1.
Remove brake handle from parking brake lever.
Loosen set screw on parking brake control lever knob.
Turn knob on parking brake lever counterclockwise all
the way to loosen brake cable adjustment.
8. Adjust parking brake lever (see Operator’s Manual)
and check operation of brakes before using the vehicle.
8
7
2.
Remove knobs from control levers and then remove
center console control plate to gain access to parking
brake cables.
4
5
9
6
10
3.
Jack up and support rear of vehicle (see Jacking In-
3
2
structions in Operator’s Manual).
4.
Remove rear wheel and brake drum (see Brake Ser-
vice in this section).
5.
Disconnect cable from rear brake (Fig. 12):
1
A. Remove clip that holds brake cable into brake
backing plate.
11
Figure 11
1.
2.
3.
4.
5.
6.
Parking brake lever
Cable equalizer bracket
Cotter pin
Clevis pin
Retaining ring (2 used)
LH brake cable
7.
8.
9.
10. Brake handle
11. Lever support bracket
RH brake cable
Washer
B. Remove parking brake cable end from parking
brake lever on brake shoe.
Bellcrank
6.
Remove retaining ring that secures brake cable to le-
ver support bracket (Fig. 11).
7.
(Fig. 13).
Disconnect brake cable from brake equalizer plate
1
4
8.
Note routing of parking brake cable and location of
2
cable ties used to secure brake cable. Remove brake
cable from vehicle.
Installation (Fig. 11)
3
1.
Connect brake cable to rear brake by inserting cable
through brake backing plate and into parking brake le-
ver. Install brake cable clip to secure cable to backing
plate (Fig. 12).
Figure 12
1.
2.
Rear brake backing plate
Parking brake lever
3.
4.
Brake shoe grooves
Brake cable clip
2.
After installing cable to rear brake, check to make
sure bottoms of brake shoes are seated in grooves at
bottom of backing plate.
3
1
3.
Route brake cable in same location as before and se-
cure with cable ties. Start from rear of vehicle and work
towards front.
2
4.
Install brake cable end to brake equalizer on parking
brake lever. Secure brake cable to lever support bracket
with retaining ring (Fig. 13).
1
Figure 13
3.
5.
Service in this section).
Install rear brake drum and rear wheel (see Brake
1.
2.
Brake cable
Retaining ring
Equalizer bracket
6.
Lower vehicle to ground.
Chassis
Page 7 – 22
Workman 3000/4000 Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Workman 3000, Toro Workman 4000 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)