Drive Shaft Cross and Bearing Service
1.
Remove drive shaft from vehicle (see Differential
Drive Shaft Removal).
3
2.
Remove snap rings that secure bearings.
2
IMPORTANT: Yokes must be supported when re-
moving and installing bearings to prevent damage.
1
3.
Use a press to remove cross and bearings from
yokes. Thoroughly clean drive shaft yokes.
4
4.
To install new cross and bearings:
A. Apply a coating of grease to all bearing bores.
B. Press one bearing partially into yoke.
C. Insert cross into yoke and bearing.
3
Figure 60
D. Hold cross in alignment and press bearing in until
it hits the yoke.
1.
2.
Flange yoke
3.
Snap ring (4 used)
Tube yoke
Cross and bearing kit
4.
E. Install snap ring into yoke groove to secure instal-
led bearing.
F. Place second bearing into yoke bore and onto
cross shaft. Press bearing into yoke and secure with
snap ring.
G. Repeat procedure for other yoke.
H. Grease cross until grease comes out of all four (4)
cups.
5.
Reinstall drive shaft to vehicle (see Differential Drive
Shaft Installation).
Workman 4000 Series
Page 10 – 31
Front Wheel Drive (4WD)
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Workman 3000, Toro Workman 4000 |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |