NOTE: Gear Pump P3 supplies oil flow for the steering
and lift circuits.
IMPORTANT: The pump is a positive displacement
type. If pump flow is completely restricted or
stopped, damage to the pump, tester or other com-
ponents could occur.
Procedure for Gear Pump P3 Flow Test
1.
Make sure hydraulic oil is at normal operating tem-
peraturebyoperatingthemachineforapproximatelyten
minutes. Make sure the hydraulic tank is full.
8.
While watching pressure gauges, slowly close flow
control valve on tester until 1000 PSI (69 bar) is ob-
tained on pressure gauge. Verify engine speed contin-
ues to be correct (2870 RPM).
(10)
2.
Park machine on a level surface with the cutting
decks lowered and off. Make sure engine is off and the
parking brake is engaged.
9.
be approximately 6.3 GPM (23.8 LPM).
For a pump in good condition, flow indication should
3.
Raise hood to allow access to pump assembly.
10.Fully
open flow control valve on tester and then shut
engine off. Record test results.
CAUTION
11.
If the flow is lower than 5.3 GPM (20.1 LPM) or a
pressure of 1000 PSI (69 bar) could not be obtained,
check for restriction in pump intake line. If intake line is
not restricted, remove gear pump and repair or replace
as necessary.
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the beginning
of this section.
12.Lower
and secure hood after testing is completed.
4.
Thoroughly clean junction of hydraulic hose and fit-
ting in gear pump section P3 (Fig. 53). Disconnect hy-
draulic hose from fitting.
RIGHT
FRONT
IMPORTANT: Make sure that the oil flow indicator
arrow on the tester is showing that the oil will flow
from the gear pump fitting, through the tester and
into the disconnected hose.
2
5.
Install tester with pressure gauges and flow meter in
series with the disconnected hose and fitting in gear
pump section P3. Make sure the flowcontrol valveon
the tester is fully open.
6.
speed. Check for hydraulic leakage and correct before
proceeding with test.
After installing tester, start engine and run at idle
1
7.
gage the cutting decks.
Move throttle to full speed (2870 RPM). DO NOT en-
Figure 53
1.
Gear pump section P3
2.
Pump section P3 hose
Groundsmaster 4500--D/4700--D
Page 4 -- 63
Hydraulic System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 30857, Toro Groundsmaster 30858, Toro Groundsmaster 4500 D, Toro Groundsmaster 4700 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)