Replace Hydraulic Oil Filter
The hydraulic system filter must be changed initially, af-
ter the first 10 hours of operation, and thereafter every
200
hours of operation or yearly, whichever comes first.
The hydraulic oil must be changed every 400 hours of
operation or yearly, whichever comes first.
1
Use a genuine Toro oil filter for replacement.
IMPORTANT: Use of any other filter may void the
warranty on some components.
2
1.
Position machine on a level surface, lower the cut-
ting units, stop the engine, engage the parking brake
and remove key from ignition switch.
Figure 38
2.
Clamp hose leading to the oil filter head from the hy-
draulic tank to prevent draining the hydraulic tank.
1.
Hydraulic oil filter
2.
Rear wheel
3.
Clean area around filter mounting surface. Place
6.
Remove clamp from hydraulic hose. Check and ad-
drain pan under filter and remove filter. Properly dispose
of filter.
just hydraulic oil level in hydraulic tank.
7.
purge air from the system. Stop the engine and check for
leaks.
Start engine and let run for about two minutes to
4.
draulic fluid.
Lubricate new filter gasket and fill the filter with hy-
5.
Assure filter mounting area is clean. Screw filter on
8.
Check level of fluid and add enough to raise level to
until gasket contacts mounting plate. Then tighten filter
one−half turn.
FULL mark on dipstick. DO NOT OVER FILL.
Hydraulic System (Rev. C)
Reelmaster 3100−D
Page 4 − 60
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Reelmaster 3100-D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |