Toro 99024SL Rev E Reelmaster 3100 D Preface Publication Service Manual

2.
Conduct a hydrometer test of the battery electrolyte.
D. Measure the temperature of the center cell.
IMPORTANT: Make sure the area around the cells is
clean before opening the battery caps.
E.  Connect a battery load tester to the battery termi-
nals following  the manufacturer’s  instructions.
Connect a digital multimeter to the battery terminals.
A.  Measure the specific gravity  of each cell with  a
hydrometer.  Draw  electrolyte   in  and  out  of   the
hydrometer barrel prior to taking a reading to warm−
up the hydrometer. At the  same time take the tem-
perature of the cell.
F.  Apply a test load of one half the Cranking Perfor-
mance (see Battery Specifications) rating of the bat-
tery for 15 seconds.
G. Take  a voltage reading at  15 seconds, then re-
move the load.
B.  Temperature correct each cell reading. For each
10
oF (5.5oC) above 80oF (26.7oC) add 0.004 to the
specific gravity reading. For each  10oF (5.5oC) be-
low 80oF (26.7oC)  subtract 0.004 from the specific
H. Using  the table  below, determine the  minimum
voltage for the cell temperature reading.
gravity reading.
Minimum
Voltage
Battery Electrolyte
Temperature
Example:  Cell Temperature
Cell Gravity
100oF
1.245
100
(37.7
20
(11
oF minus 80oF equals 20oF
oC minus 26.7oC equals 11.0oC)
oF   multiply by 0.004/10oF equals 0.008
oC   multiply by 0.004/5.5oC equals 0.008)
9.6
9.5
9.4
9.3
9.1
8.9
8.7
8.5
70oF (and up)
60oF
21.1oC (and up)
15.6oC
10.0oC
4.4oC
50oF
40oF
ADD (conversion above)
Correction to 80oF (26.7oC)
0.008
1.253
30oF
20oF
10oF
0oF
−1.1oC
−6.7oC
−12.2oC
−17.8oC
C. If the difference between the highest and lowest
cell specific gravity is 0.050 or greater or the lowest
cell specific gravity is less than 1.225, charge the bat-
tery. Charge at the recommended rate and time giv-
en in  Charging or  until all cells  specific gravity  is
1.225
or greater with the difference in specific gravity
I.   If the test voltage is below the minimum, replace
the battery. If the test voltage is at or above the mini-
mum, return the battery to service.
between the highest and lowest cell less than 0.050.
If these charging conditions can not be met, replace
the battery.
Installation
3.
Perform a  high−discharge  test with  an adjustable
load tester.
IMPORTANT: To  prevent  possible electrical  prob-
lems, install only a fully charged battery.
This is one of the most reliable means of testing a battery
as it simulates the cold−cranking test. A commercial bat-
tery load tester is required to perform this test.
1.
Make sure ignition and all accessories are off.
2.
Make  sure battery  compartment  is clean  and  re-
painted if necessary.
CAUTION
3.
Make sure all battery cables and connections are in
good condition and battery retainer has  been repaired
or replaced.
Follow the manufacturer’s instructions when us-
ing a battery tester.
4.
Place battery in its compartment. Make sure battery
is level and flat. Connect positive cable connector onto
positive battery  post. Tighten cap  screw and  lock nut
with two wrenches.
A.  Check the voltage  across the battery  terminals
prior to testing the battery. If the voltage is less than
12.4
VDC, recharge the battery.
IMPORTANT: The nut must be on top of the battery
retainer during installation to prevent the cap screw
from hitting hydraulic hard lines when the sidewind-
er is shifted.
B.  If the battery has been charged, apply a 150 amp
load for 15 seconds to  remove the surface charge.
Use a battery load tester  following the manufactur-
er’s instructions.
5.
vent cracking or distorting the battery case.
Secure battery retainer.  Do not overtighten  to pre-
C. Make sure battery terminals are free of corrosion.
Electrical Systems (Rev. C)
Page 5 − 44
Reelmaster 3100−D
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 264 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website