Adjust Front Lift Arms
1.
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2
1
IMPORTANT: Keep front cutting units on the lift
arms when performing this adjustment.
3
2.
Raise front lift arms. Make sure clearance between
each lift arm and floor plate bracket is 0.18 to 0.32 inch
to 8.1 mm) (Fig. 10).
(4.6
3.
If the clearance is not in this range, attain proper
clearance as follows:
Figure 10
A. Back off stop bolts if reducing the clearance be-
tween the stop bolt and lift arm (Fig. 11).
1.
2.
Lift arm
Floor plate bracket
3.
Clearance
B. Adjust front hydraulic cylinder by backing off jam
nut on the cylinder, removing the pin from the clevis,
and rotating the clevis (Fig. 12).
1
C. Install pin to clevis and check clearance. Repeat
steps A and B if necessary.
2
3
4.
Make sure clearance between each lift arm and stop
bolt is 0.005 to 0.040 inch (0.127 to 1.02 mm). If the
clearance is not in this range, adjust stop bolts as neces-
sary (Fig 11).
IMPORTANT: The lack of clearance at the front
stops can damage the lift arms.
5.
Install both front cutting units to the lift arms (see Cut-
ting Unit Removal and Installation).
Figure 11
1.
2.
Stop bolt
Lift arm
3.
Clearance
2
1
Figure 12
1.
Hydraulic cylinder
2.
Jam nut
Reelmaster 3100−D
Page 7 − 11
Cutting Units
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Reelmaster 3100-D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)