Hydraulic Control Manifold: Deck Drive
23
7
24
3
22
25
21
2
12
20
194
10
11
4
6
5
4
3
2
4
18
13
26
8
12
6
10
7
10
9
1
17
2
7 16 1015
12
11
14
RIGHT
FRONT
Figure 52
1.
2.
3.
4.
5.
6.
7.
8.
9.
Hydraulic manifold (front deck)
Quick fitting
10. O--ring
19. Elbow (90o)
11. Cap screw
12. Fitting cap
13. Adapter
20. Hydraulic fitting
21. O--ring
Flange nut
O--ring
22. O--ring
Hydraulic fitting
O--ring
14. Adapter
15. Straight hydraulic fitting
16. Adapter
17. O--ring
18. Hydraulic fitting
23. Adapter
24. O--ring
25. Hydraulic manifold (RH deck)
26. Hydraulic manifold (LH deck)
O--ring
45o hydraulic fitting
Adapter
Removal
3. Disconnect hydraulic lines from manifold and put
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
NOTE: The ports on the manifold are marked for easy
identification of components. Example: SV1 is the deck
solenoid valve and P1 is a gear pump connection port.
(See Hydraulic Schematics toidentify thefunction ofthe
hydraulic lines and cartridge valves at each port).
4. Remove hydraulic manifold from the frame using
Figure 52 as guide.
Installation
1.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
1.
52
Install hydraulic manifold to the frame using Figure
as guide.
2.
Properly connect hydraulic lines to manifold.
Remove caps and plugs from fittings and hoses.
2.
valve.
Disconnect electrical connector from the solenoid
3.
Connect electrical connector to the solenoid valve.
Groundsmaster 4000--D
Hydraulic System (Rev. B)
Page 4 -- 70
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)