Hydraulic Control Manifold: Cutting Deck Lift/Lower
12
16
15
10
13
5
14
9
1
3
RIGHT
2
FRONT
10
4
11
8
9
7
10
5
6
Figure 54
1.
2.
3.
4.
5.
6.
Lift/lower hydraulic manifold
Valve plate
7.
8.
9.
Lock nut
12. Cap screw
Hydraulic fitting
O--ring
13. 90o hydraulic fitting
Flat washer
14. O--ring
15. Test nipple
16. Fitting cap
Cap screw
10. O--ring
Grommet
11. 90o hydraulic fitting
Flat washer
Removal
Installation
NOTE: The ports on the manifold are marked for easy
identification of components. Example: C1 is the con-
nectionportfromtheLHdeckliftcylinderandCHGisthe
charge circuit connection (See Hydraulic Schematics to
identify the function of the hydraulic lines and cartridge
valves at each port).
1. Install hydraulic manifold to the frame using Figure
54 as guide.
2.
Remove caps and plugs from fittings and hoses.
Properly connect hydraulic lines to manifold.
1.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
2.
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
Disconnect hydraulic lines from manifold and put
3.
Remove hydraulic manifold from the frame using
Figure 54 as guide.
Hydraulic System (Rev. B)
Page 4 -- 72
Groundsmaster 4000--D
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)