Differential Shafts
The following procedures assume the rear axle assem-
bly has been removed from the machine.
35
(47
to 41 ft−lb
to 56 N−m)
Removal
1
6
5
IMPORTANT:
Do not interchange right and left dif-
ferential shaft assemblies.
1.
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 23).
Remove the mounting screws, nuts, and lock wash-
4
2
3
7
35
(47
to 41 ft−lb
to 56 N−m)
2.
axle support.
Mark and pull the differential shaft assembly from the
Figure 23
5.
assembly
6.
7.
3.
4.
Remove the retaining ring and bevel gear (Fig 24).
Drive the differential shaft out of the bearings. Re-
1.
2.
3.
4.
Cap screw
Lock nut
Lock washer
Axle support
Bevel gear/axle case
O-ring
Stud
move the bearings and bearing shims.
5.
Inspect all gears, shafts, bearings, and cases for
damage and wear. Replace components as necessary.
Installation
1.
Press bearings onto differential shaft. Place correct
6
combination of bearing shims in axle support and drive
differential shaft and bearing assembly into axle sup-
port.
3
5
4
2
1
2.
3.
Install bevel gear and retaining ring.
Coat new O-ring with grease. Align differential shaft
splines with differential gear assembly and slide differ-
ential shaft assembly onto axle support.
4.
Bevel Gear Case/Axle Case Assembly in this section of
this manual).
Install bevel gear case/axle case assembly (see
Figure 24
4.
5.
6.
1.
2.
3.
Retaining ring
Bevel gear
Differential shaft
Bearing
Bearing shims
O-ring
Axles, Planetaries, and Brakes (Rev. B)
Page 6 − 20
Groundsmaster 4000−D
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)