General Safety Instructions
The GROUNDSMASTER 4000-D was tested and certi-
fied by TORO for compliance with the B71.4-1999 speci-
fications of the American National Standards Institute.
Although hazard control and accident prevention par-
tially are dependent upon the design and configuration
of the machine, these factors are also dependent upon
the awareness, concern, and proper training of the per-
sonnel involved in the operation, transport, mainte-
nance, and storage of the machine. Improper use or
maintenance of the machine can result in injury or
death. To reduce the potential for injury or death, comply
with the following safety instructions.
WARNING
To reduce the potential for injury or death,
comply with the following safety instructions.
Before Operating
1.
Read and understand the contents of the Operator’s
3. Assure interlock switches are adjusted correctly so
engine cannot be started unless traction pedal is in
NEUTRAL and cutting units are DISENGAGED.
Manual before starting and operating the machine. Be-
come familiar with the controls and know how to stop the
machine and engine quickly. A replacement Operator’s
Manual is available on the Internet at www.Toro.com or
by sending the complete model and serial number to:
4.
Since diesel fuel is highly flammable, handle it care-
fully:
A. Use an approved fuel container.
The Toro Company
Attn. Technical Publications
B. Do not remove fuel tank cap while engine is hot or
running.
8111
Lyndale Avenue South
Bloomington, Minnesota 55420−1196
C. Do not smoke while handling fuel.
2.
Keep all shields, safety devices, and decals in place.
If a shield, safety device, or decal is defective, illegible
or damaged, repair or replace it before operating the
machine. Also tighten any loose nuts, bolts or screws to
ensure machine is in safe operating condition.
D. Fill fuel tank outdoors and only to within an inch of
the top of the tank, not the filler neck. Do not overfill.
E. Wipe up any spilled fuel.
While Operating
1.
chine.
Sit on the seat when starting and operating the ma-
5. Before getting off the seat:
A. Ensure that traction pedal is in neutral.
B. Set parking brake.
2.
Before starting the engine:
A. Engage the parking brake.
C. Disengage cutting units and wait for blades to
stop.
B. Make sure traction pedal is in neutral and the
PTO switch is OFF (disengaged).
D. Stop engine and remove key from switch.
C. After engine is started, release parking brake and
keep foot off traction pedal. Machine must not move.
If movement is evident, the traction pedal linkage is
adjusted incorrectly; therefore, shut engine off and
adjust until machine does not move when traction
pedal is released.
E. Toro recommends that anytime the machine is
parked (short or long term), the cutting units should
be lowered to the ground. This relieves pressure
from the lift circuit and eliminates the risk of cutting
units accidentally lowering to the ground.
F. Do not park on slopes unless wheels are chocked
or blocked.
3.
quate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
Do not run engine in a confined area without ade-
4.
Do not touch engine, muffler or exhaust pipe while
engine is running or soon after it is stopped. These areas
could be hot enough to cause burns.
Safety
Groundsmaster 4000−D
Page 1 − 2
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)