Removal
Installation
1.
stop engine, engage parking brake, and remove key
from the ignition switch.
Park machine on a level surface, lower cutting units,
1. Positionwheelmotortobrakeassemblymakingsure
that arrows on the side of motor case point upward.
2.
Align splines on motor shaft and splined brake shaft.
2.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
Slide motor into brake assembly.
3.
Secure motor to brake assembly with cap screws
and flat washers. Tighten cap screws from 75 to 85 ft--lb
(101 to 115 N--m).
NOTE: To ease reassembly, tag the hydraulic hoses to
show their correct position on the wheel motor.
4.
Remove plugs from ports. Attach hydraulic hoses
3.
motor. Put caps or plugs on ports to prevent contamina-
tion.
Disconnect hydraulic hoses and tubes from wheel
and tubes to wheel motor.
5.
Fillreservoir with hydraulic fluid asrequired (seeOp-
erator’s Manual).
IMPORTANT: Before loosening fasteners, support
wheel motor to prevent motor fromfalling during re-
moval.
4.
Remove wheel motor using Figure 61 as a guide.
Groundsmaster 4000--D
Page 4 -- 81
Hydraulic System (Rev. B)
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)