Planetary Wheel Drive Removal
Park machine on a level surface, lower cutting units,
WARNING
1.
stop engine, engage parking brake, and remove key
from the ignition switch.
Failure to maintain proper wheel lug nut
torque could result in failure or loss of wheel
and may result in personal injury.
2.
Drain oil from planetary wheel drive/brake assembly
(see Operator’s Manual).
4.
Install wheel assembly. Torque lug nuts from 85 to
100
ft−lb (115 to 135 N−m).
CAUTION
5.
Lower machine from jack stands.
When changing attachments, tires, or perform-
ing other service, use correct blocks, hoists,
and jacks. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and
proper raising of the machine. Always chock or
block wheels. Use jack stands or solid wood
blocks to support the raised machine. If the ma-
chine is not properly supported by blocks or
jack stands, the machine may move or fall,
which may result in personal injury.
6. Make sure drain plug is installed in bottom of brake
assembly (Fig. 6). Fill planetary wheel drive/brake as-
sembly with SAE 85W−140 gear lube (see Operator’s
Manual). Capacity is approximately 16 oz. (.47 l) per
wheel.
7.
Check and adjust brake cables for proper brake op-
eration (see Operator’s Manual).
1
3.
Chock rear wheels and jack up front of machine (see
Jacking Instructions in Chapter 1 − Safety). Support ma-
chine with jack stands or solid wood blocks.
2
4.
Remove front wheel assembly.
5.
Remove hydraulic wheel motor (see Front Wheel
Motors in Service and Repairs section of Chapter 4 −
Hydraulic System).
6.
Remove brake assembly (see Brake Assembly).
3
7.
Support planetary assembly to prevent it from falling.
Loosen and remove flange head screws that secure
planetary assembly to frame. Remove planetary as-
sembly from machine.
Figure 6
1.
2.
Brake housing
Check plug
3. Drain plug
Planetary Wheel Drive Installation
1.
Position planetary assembly to machine. Install
flange head screws that secure planetary assembly.
Torque screws from 75 to 85 ft−lb (101 to 115 N−m).
2.
Install brake assembly (see Brake Assembly).
3.
Install hydraulic wheel motor (see Front Wheel Mo-
tors in Service and Repairs section of Chapter 4 − Hy-
draulic System).
Groundsmaster 4000−D
Page 6 − 9
Axles, Planetaries, and Brakes (Rev. B)
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)