Hydraulic Manifold: Flow Divider
9
16
8
10
15
14
7
17
18
19
11
13
12
2
8
1
2
3
5
4
RIGHT
6
FRONT
5
Figure 58
1.
2.
3.
4.
5.
6.
7.
Hydraulic manifold
O--ring
Hydraulic fitting
Bracket
Flange nut
Cap screw (2 used)
Hydraulic hose
8.
9.
O--ring
14. O--ring
90o hydraulic elbow
15. 90o hydraulic elbow
10. O--ring
16. O--ring
11. Hydraulic hose
12. Hydraulic fitting
13. O--ring
17. Cap screw
18. O--ring
19. Hydraulic fitting
NOTE: The hydraulic Flow Divider is included as a hy-
draulicsystemcomponentonmachineswithserialnum-
bers above 230000000. The Flow Divider was an
optional kit for earlier production machines (serial num-
bers below 220999999).
2. Disconnect hydraulic lines from manifold and put
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
3.
Remove hydraulic manifold from the frame using
Figure 58 as guide.
Removal
Installation
NOTE: The ports on the manifold are marked for easy
identification of hydraulic line connections. Example: P
is the traction pump connection port and M1 is the con-
nection for the front traction motors (See Hydraulic
Schematics to identify the function of the hydraulic lines
and cartridge valves at each port).
1.
58
Install hydraulic manifold to the frame using Figure
as guide.
2.
Properly connect hydraulic lines to manifold.
Remove caps and plugs from fittings and hoses.
1.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
Hydraulic System (Rev. B)
Page 4 -- 76
Groundsmaster 4000--D
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)