Removal
Installation
1.
stop engine, engage parking brake, and remove key
from the ignition switch.
Park machine on a level surface, lower cutting units,
1. Place a washer onto each ball joint. Slide ram end
ball joint through hole on steering arm. Secure with axle
washer and hex slotted nut. Slide fixed end of cylinder
through hole on axle. Install spacer onto ball joint and
securewithhexslottednut.Torqueslottednutsfrom100
to 125 ft--lbs (135 to 169 N--m) prior to inserting cotter
pins.
2.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
NOTE: To ease reassembly, tag the hydraulic hoses to
show their correct position on the steering cylinder.
2.
3.
Install hydraulic hoses to steering cylinder.
Fillreservoir with hydraulic fluid asrequired (seeOp-
3.
4.
Remove hydraulic hoses from steering cylinder.
Remove cotter pins, hex slotted nuts, axle washer,
erator’s Manual).
4.
After assembly is completed, operate steering cylin-
andballjointspacerfromthethreaded endsofballjoints
(Fig. 81). Remove steering cylinder with ball joints from
machine. Locate and retrieve ball joint spacers from top
of axle assembly.
dertoverifythathydraulichosesandfittingsarenotcon-
tacted by anything.
Groundsmaster 4000--D
Page 4 -- 105
Hydraulic System (Rev. B)
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)