Removal
Installation
1.
stop engine, engage parking brake, and remove key
from the ignition switch.
Park machine on a level surface, lower cutting units,
1. If removed, install pinion gear to axle motor.
2.
Install o--ring onto motor. Position motor to rear axle
assembly making sure that arrows on the side of motor
case point upward. Align gear teeth and slide motor into
place.
2.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the General Precautions for Removing and
3.
Secure motor to axle with cap screws and flat wash-
NOTE: To ease reassembly, tag the hydraulic hoses to
ers. Torque screws from 59 to 73 ft--lb (80 to 99 N--m).
show their correct position on the axle motor.
4.
Remove plugs from ports. Attach hydraulic hoses to
3.
plugs on ports to prevent contamination.
Disconnect hydraulic hoses from motor. Put caps or
axle motor.
5.
Fillreservoir with hydraulic fluid asrequired (seeOp-
IMPORTANT: Support axle motor to prevent motor
from falling during removal.
erator’s Manual).
6.
After assembly is completed, verify that hydraulic
4.
Remove motor using Figure 60 as a guide.
hoses and fittings do not contact anything.
Groundsmaster 4000--D
Page 4 -- 79
Hydraulic System (Rev. B)
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)