Removal
3
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the muf-
fler.
2
4
1.
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2.
Remove muffler and/or muffler bracket from the en-
gine as necessary using Figure 5 as a guide.
1
Installation
Figure 6
Note:
Make sure muffler flange and exhaust manifold
sealing surfaces are free of debris or damage that may
prevent a tight seal.
1.
Install new gasket if original gasket is damaged or
torn.
IMPORTANT: Failure to follow the suggested muf-
fler fastener sequence may result in premature muf-
fler failure.
2.
Install muffler and/or muffler bracket to the engine
using Figure 5 as a guide. Hand tighten and then torque
the following fasteners from 16 to 22 ft−lb (21 to 29 N−m)
in the sequence listed (Fig. 6):
A. Locknuts used on rubber hanger cap screws.
B. Flange nuts that secure muffler to muffler brack-
et.
C. Flange head screws that secure muffler flange to
engine.
D. Flange nuts that secure muffler bracket to en-
gine.
3.
Tailpipe should have equal clearance between frame
and engine after installation.
Groundsmaster 4000−D
Page 3 − 9
Kubota Diesel Engine (Rev. B)
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro Groundsmaster 4000 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)