Power Relay (Four Terminals)
The main power relay is used toprovide electrical power
to the majority of the Workman circuits. When the igni-
tion key is in either the ON or START position, the main
power relay is energized. The main power relay is at-
tachedtotherelaybracketundertherightsideofthebed
near the rear axle (Fig. 19).
1
1
HDX MODELS
Besides the main power relay, Workman HDX--D ve-
hicles (diesel engine) use an additional power relay to
supply electrical power to the glow plugs. The glow plug
controller determines when the glow relay is energized.
The glow relay is attached to the relay bracket (Fig. 19).
2
HDX--D MODELS
Testing
1.
gine, apply parking brake and remove key from ignition
switch.
Park machine on a level surface, raise bed, stop en-
1
2.
Install bed support on bed lift cylinder to prevent bed
from lowering.
HD MODELS
3.
machine wire harness connector from the relay. Re-
move relay from machine for easier testing.
Locate power relay to be tested and disconnect the
Figure 19
1.
Main power relay
2.
Glow relay
NOTE: Prior to taking small resistance readings with a
digital multimeter, short the meter test leads together.
The meter will display a small resistance value (usually
0.5
ohms or less). This resistance is due to the internal
86
85
87
30
30
resistance of the meter and test leads. Subtract this val-
ue from from the measured value of the component you
are testing.
85
86
87
4.
Verify coil resistance between terminals 85 and 86
with a multimeter (ohms setting) (Fig. 20). Resistance
should be approximately 72 ohms.
Figure 20
5.
Connect multimeter (ohms setting) leads to relay ter-
minals 30 and 87. Ground terminal 86 and apply +12
VDCtoterminal85.Therelay shouldhavecontinuity be-
tween terminals 30 and 87 as +12 VDC is applied to ter-
minal 85. The relay should not have continuity between
terminals 30 and 87 as +12 VDC is removed from termi-
nal 85.
6.
Replacerelayiftestingdeterminesthatrelayisfaulty.
7.
After testing is complete, install relay to relay bracket
and connect wire harness connector to relay.
Remove bed support from lift cylinder and lower bed.
8.
Electrical System
Page 8 -- 16
Workman HD Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)