Driveshaft Cross and Bearing Service
1.
moval in this section).
Remove driveshaft from vehicle (see Driveshaft Re-
5. Lubricate grease fittings until grease purges from
bearing cups. Make sure to grease all cross fittings.
IMPORTANT: When placing yoke in vise, clamp
lightly on the solid part of the yoke to prevent yoke
damage. Also, the use of a vise with soft jaws is rec-
ommended.
6. Make sure that assembled joint moves without bind-
ing. Slight binding can usually be eliminated by lightly
rapping the yoke lugs with a soft faced hammer. If bind-
ing continues, disassemble joint to identify source of
binding.
2.
Lightly clamp yoke in vise. Remove snap rings that
secure bearings at the inside of each yoke. Remove
yoke from vise.
7. Install driveshaft to vehicle (see Driveshaft Installa-
tion in this section).
IMPORTANT: Yokes must be supported when re-
moving and installing bearings to prevent damage.
6
3.
Use a press to remove cross and bearings from
2
yokes:
4
A. Place a small socket against one bearing and a
5
large socket against the yoke on the opposite side.
7
B. Whilesupportingthelargesocket,applypressure
onsmallsocket topartially pushtheoppositebearing
into the large socket.
2
3
C. Remove yoke from press, grasp partially re-
moved bearing and tap on yoke to completely re-
move the bearing.
1
D. Repeat process for remaining bearings.
E. Thoroughly clean and inspect all components.
To install new cross and bearings:
1
Figure 9
5.
6.
7.
1.
2.
3.
4.
Snap ring
Seal
End yoke
Tube yoke
4.
Cross and bearings
End yoke
A. Apply a coating of grease to bearing bores of end
yoke and shaft yoke. Also, apply grease to bearings
and seal of bearing assembly. Make sure that all
bearing rollers are properly seated in bearing cage.
Yoke and hub
B. Press one bearing partially into yoke.
IMPORTANT: Take care when installing cross
into bearing to avoid damaging bearing seal.
C. Carefully insert cross into bearing and yoke.
D. Hold cross in alignment and press bearing in until
it hits the yoke.
E. Carefully place second bearing into yoke bore
and onto cross shaft. Press bearing into yoke.
F. Install snap rings to bearings to secure bearings
in place.
G. Repeat procedure for remaining yoke.
Drive Train
Page 6 -- 14
Workman HD Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)