Driveshaft Cross and Bearing Service
5
1
2
4
3
5
2
1
5
5
Figure 7
1.
2.
Yoke
Cross and bearing kit
3.
4.
Yoke and shaft
Yoke and tube
5.
Snap ring
Disassembly (Fig. 7)
Remove driveshaft fromvehicle (seeDifferentialDri-
Assembly (Fig. 7)
1.
1. To install new cross and bearings:
veshaft Removal in this section).
A. Apply a coating of grease to bearing bores of end
yoke and shaft yoke. Also, apply grease to bearings
and seal of bearing assembly. Make sure that all
bearing rollers are properly seated in bearing cage.
IMPORTANT: When placing yoke in vise, clamp
lightly on the solid part of the yoke to prevent yoke
damage. Also, the use of a vise with soft jaws is rec-
ommended.
B. Press one bearing partially into yoke.
2.
to carefully remove snap rings that secure bearings at
the inside of each yoke. Remove yoke from vise.
Lightly clamp yoke in vise. Use two (2) screwdrivers
IMPORTANT: Take care when installing cross
into bearing to avoid damaging bearing seal.
C. Carefully insert cross into bearing and yoke.
IMPORTANT: Yokes must be supported when re-
moving and installing bearings to prevent damage.
D. Hold cross in alignment and press bearing inuntil
it hits the yoke.
3.
Use a press to remove cross and bearings from
yokes:
E. Carefully place second bearing into yoke bore
and onto cross shaft. Press bearing into yoke.
A. Place a small socket against one bearing and a
large socket against the yoke on the opposite side.
F. Install snap rings to bearings to secure bearings
in place.
B. While supporting the large socket, apply pres-
sure on small socket to partially push the opposite
bearing into the large socket.
G. Repeat procedure for other yoke.
H. Greasecrossuntilgreasecomesoutofallfour(4)
bearing cups.
C. Remove yoke from press, grasp partially re-
moved bearing and tap on yoke to completely re-
move the bearing.
2.
Make sure that assembled joint moves without bind-
ing. Slight binding can usually be eliminated by lightly
rapping the yoke lugs with a soft faced hammer. If bind-
ing continues, disassemble joint to identify source of
binding.
D. Repeat process for remaining bearings.
E. Thoroughly clean and inspect all components.
3.
Install driveshaft to vehicle (see Differential Drive-
shaft Installation in this section).
Front Wheel Drive (4WD)
Page 10 -- 10 Workman HDX/HDX--D
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)