3.
If engine mount was removed, secure mount to en-
12.Install upper and lower radiator hoses to engine and
secure with hose clamps. Install R--clamp (item 35) to
secure lower radiator hose to engine mount.
gine with seven (7) flange head screws. Do not install
the screw used to secure the ground connections to the
engine at this time.
13.Fill
radiator with coolant.
4.
gine mount (see Gear Pump Installation in the Service
and Repairs section of Chapter 9 -- Hydraulic System).
If gear pump was removed, install gear pump to en-
14.Connect
nents. Secure wire harness to machine with cable ties
in locations noted during engine removal.
wire harness connectors to engine compo-
5.
14).
Install two (2) dowel pins in bell housing bores (Fig.
15.Secure
engine (see Engine Throttle Bracket Assembly in this
section).
accelerator cable ball joint to throttle lever on
6.
Make surethat snubbing washer ispositioned ontop
of both engine mounts (Fig. 13).
16.Install
clamp.
airintakehosetoengine andsecure withhose
7.
Use lift or hoist to install engine to chassis. One per-
son should operate hoist and second person should
helpguideenginetomachine.Alignsplinesontransaxle
input shaft and clutch while moving engine to bell hous-
ing on transaxle.
17.Connect
pump on engine. Secure hoses with hose clamps.
fuelsupplyandreturnhosestofuelinjection
18.Install
exhaust tube to vehicle (see Exhaust System
Installation in this section).
8.
Securebellhousingtoenginewithsix(6)capscrews
and two (2) harness brackets (Fig. 14).
19.Install
rect oil.
a new engine oil filter. Fill engine with the cor-
9.
Secure engine mount to engine support with two (2)
cap screws, snubbing washers and flange nuts (Fig.
13).
20.Connect
cables to the battery.
positive (+) and then negative (--) battery
10.Remove
plugs from hydraulic hoses and gear pump
21.Adjust
22.Check
just if necessary (see Adjust Engine Speed in Adjust-
ments section of this chapter).
accelerator cable (see Operator’s Manual).
engine speed(both idleand highidle) andad-
fittings. Connect hydraulic hoses to gear pump (see Hy-
draulic Hose and Tube Installation in the General Infor-
mation section of Chapter 9 -- Hydraulic System).
11.
On 4WD vehicles, install differential drive shaft (see
DifferentialDriveshaftInstallationintheServiceandRe-
pairs section ofChapter 10 -- FrontWheel Drive (4WD)).
Workman HDX--D
Briggs/Daihatsu Diesel Engine
Page 4 -- 17
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)