Transaxle Removal (Fig. 12)
Park vehicle on a level surface. Stop the engine and
1.
remove key fromignition switch. Remove thebed oroth-
er attachment(s). Allow transaxle and engine to cool.
1
2.
Disconnect negative (--) battery cable from battery
first.Thendisconnectpositive(+)batterycablefrombat-
tery(seeBatteryServiceintheServiceandRepairssec-
tion of Chapter 8 -- Electrical System).
2
3
3.
low oil to drain into a suitable drain pan. Install drain plug
after draining is complete.
Remove drain plug from bottom of transaxle and al-
Figure 13
3.
4.
Note orientation of 90o fitting (item 17) connected to
strainer on side of transaxle. Remove hydraulic hose
and 90o fitting from strainer.
1.
2.
Clutch cable
Clutch release lever
Support bracket
5.
and Repairs section oftheappropriate Engine Chapter).
Remove muffler (see Muffler Removal in the Service
1
6.
7.
Remove hydraulic filter assembly and bracket.
Disconnect and label electrical leads that attach to
transaxle and PTO (if equipped).
8.
then loosen jam nut to remove clutch cable from support
bracket (Fig. 13).
Disconnect clutch cable from clutch release lever,
9.
support bracket, then disconnect differential lock cable
from lock lever at left rear of transaxle (Fig. 14).
Loosen jam nutto remove differentiallock cable from
2
Figure 14
10.Disconnect
transaxle and PTO (if equipped) (Fig. 15). Do not loosen
cable jam nuts at shift cable mount bracket.
shifter control cables from levers on
1.
Differential lock cable
2.
Differential lock lever
11.
Remove shift cable mount bracket from transaxle,
keeping shifter control cables attached to bracket. Posi-
tion bracket away from transaxle.
12.On
Workman 4WD vehicles, remove differential dri-
veshaft from the transaxle (see Differential Driveshaft
Removal in the Service and Repairs section of Chapter
3
10
-- Front Wheel Drive (4WD)).
2
4
13.Disconnect
return hydraulic hose from transaxle (or
PTO if equipped). Put caps or plugs on open hose and
fitting to prevent contamination.
1
14.Remove
PTO Removal and Installation in this section).
PTO, if equipped, from top of transaxle (see
Figure 15
3.
4.
1.
2.
First--Reverse
High--Low
2nd--3rd
PTO clutch
15.Block
front wheels. Jack--up rear of vehicle and
install jack stands so transaxle can be removed by slid-
ing out from under rear axle (see Jacking Vehicle in the
Safety Instructions section of Chapter 1 -- Safety).
Workman HD Series
Page 6 -- 17
Drive Train
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)