Fuel Gauge Sender
The fuel gauge sender is located in the fuel tank (Fig.
8. After testing, install sender into fuel tank and secure
withgasketand fuelsender cap.Secure fuelhoses tofit-
tings on sender and connect fuel sender connector to
wire harness.
26).
The fuel gauge sender on Workman HDX vehicles
(liquid cooled gasoline engine) is included with the fuel
pump and fuel filter assembly that fits into the fuel tank.
Testing
9.
Remove bed support from bed lift cylinder and lower
bed.
1.
Park machine on a level surface, raise bed, stop en-
gine, apply parking brake and remove key from ignition
switch. Install bed support on bed lift cylinder to prevent
bed from lowering.
2
FUEL SENDER FROM
WORKMAN HDX--D
SHOWN
2.
Disconnect the wire harness connector (white and
4
black wires) from the fuel sender.
1
CAUTION
5
3
When testing circuit wiring and fuel gauge, make
sure wire connections are secure before turning
ignition switch to ON to prevent an explosion or
fire from sparks.
6
175
(20
to 200 in--lb
to 22 N--m)
3.
To test the circuit wiring and fuel gauge, use ajumper
wire to connect the two (2) terminals in the wire harness
connector. Make sure that jumper wire connections are
secure.TurnignitionswitchtoON.Fuelgaugeshouldin-
dicate a full fuel tank. Turn ignition switch OFF and con-
tinue testing fuel sender if circuit wiring and gauge are
acceptable.
Figure 26
4.
fuel sender cap that secures the sender in the fuel tank.
Removefuelhosesfromfuelsenderfittings.Remove
1.
2.
3.
Fuel gauge sender
Fuel sender cap
Gasket
4.
5.
6.
Fuel hose
Fuel hose
Fuel tank
5.
Remove sender and gasket from the fuel tank. Clean
all fuel from the sender.
CAUTION
Makesuresendingunitiscompletely dry(nofuel
on it) before testing. Perform test away from the
tank to prevent an explosion or fire from sparks.
1
2
6.
Check resistance of the sender with a multimeter
(Fig. 27).
A. Resistance with the float in the full position (com-
pletely up) should be from 5 to 8 ohms.
FUEL SENDER FROM
WORKMAN HD/HDX--D
SHOWN
B. Resistance with the float in the empty position
(completely down) should be from 89 to 95 ohms.
7.
Replace fuel gauge sender if necessary.
Figure 27
1.
Sender full position
2.
Sender empty position
Electrical System
Page 8 -- 20
Workman HD Series
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro 09173SL |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)