Toro 98957SL Rev B Sand Pro 2020 3020 5020 Service Manual

6.
Apply masking tape  around splines or  keyway on
coupling shaft (11) to prevent damage to seal.
IMPORTANT: The outer bearing (2) is not lubricated
byoughlythe system’spacked hydraulicwith  Mobilfluid.MobilithMake sureSHCit isRthor-460
grease.
NOTE:  Coupling shaft  (11)  should be  approximately
0.10
inch (2.54 mm) below the housing wear plate sur-
face to allow the assembly of the thrust bearing (12). The
coupling shaft must rotate smoothly on the thrust bear-
ing (9) and thrust washer (8) (Fig. 76).
Figure 75
Figure 76
Figure 77
Figure 78
7.
Make sure that a generous amount of clean corro-
sion resistant grease has been applied to the outer bear-
ing (2). Install the  coupling shaft (11) into housing  (3),
and seat shaft against the second thrust washer (8).
8.
Install thrust bearing (12) onto the end  of coupling
shaft (11).
9.
Apply a small amount of clean petroleum jelly  to a
new seal ring (5) and insert it into  the housing (3) seal
ring groove.
NOTE:  One or two alignment studs screwed finger tight
into housing (3) bolt holes, approximately 180 degrees
apart, will facilitate the assembly and alignment of com-
ponents as  required in the  following procedures.  The
studs can be made  by cutting off the heads  of 3/8–24
UNF 2A bolts so they are 0.5 inch (12.7 mm) or longer
than cap screw (14).
NOTE:  Use any alignment marks  put on the coupling
shaft (11) and drive link (13) before disassembly to as-
semble the drive link splines in their original position in
the mating coupling shaft splines.
10.
Install drive link (13) with the long splined end down
into the coupling shaft (11). Engage the drive link splines
so they mesh with the coupling shaft splines (Fig. 77).
11.
Assemble wear  plate (18) over the  drive link (13)
and alignment studs onto the housing (3) (Fig. 78).
12.
Apply a small amount of clean petroleum jelly  to a
new  seal ring  (5) and  assemble  it into  the  seal ring
groove on the wear plate side of the stator (21).
Sand Pro 2020/3020/5020
Page 4 – 67
Hydraulic System (Rev. A)
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 170 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website