Starter Solenoid
NOTE: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
SOLENOID COIL
POSTS
TOP VIEW
SIDE VIEW
MAIN CONTACT
POSTS
1.
Make sure engine is off. Disconnect solenoid elec-
trical connections.
2.
posts. The solenoid should click. Make sure continuity
across the main contact posts is less than 1 ohm.
Apply 12 VDC directly across the solenoid coil
SOLENOID COIL
POSTS
WIRING
DIAGRAM
3.
Remove voltage from solenoid coil posts. The sole-
noid should click. Make sure reading across the main
contact posts is infinity ohms.
4.
Resistance across the solenoid coil posts should be
3.1
ohms.
MAIN CONTACT
POSTS
5.
electrical connections to solenoid.
Replace starter solenoid if necessary. Reconnect
Figure 8
Neutral Switch
NOTE: Prior to taking small resistance readings with a
digital multimeter, short the test leads together. The me-
ter will display a small resistance value (usually 0.5
ohms or less). This resistance is due to the internal re-
sistance of the meter and test leads. Subtract this value
from from the measured value of the component you are
testing.
NEUTRAL
SWITCH
This switch is closed when the traction pedal is in the
neutralposition.Theswitchislocatedonthepumplever,
which is attached to the hydraulic pump assembly.
1.
Make sure the engine is off.
2.
Disconnect one of the electrical connections from
the switch terminal posts.
PUMP
LEVER
3.
Checkcontinuityoftheswitchbyconnectingamulti-
meter (ohms setting) across the connector terminals.
Figure 9
4.
With the traction pedal in the neutral position and
the switch button depressed, resistance should be less
than 1 ohm between the terminals.
5.
With the traction pedal in the the forward or back-
ward position, there the meter should read infinity
ohms across the terminals.
6.
Replace switch if necessary. Connect electrical
connections to the switch terminal posts.
Electrical Systems
Page 5 – 12
Sand Pro 2020/3020/5020
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro 3020, Toro 5020, Toro 98957SL.Toro 2020 |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)