Toro 98957SL Rev B Sand Pro 2020 3020 5020 Service Manual

2.
Determine the  charging time  and rate  using the
manufacturer’s battery charger  instructions or the
following table.
CAUTION
Do not charge a frozen battery because it can ex-
plode60_F (15.5and_causeC) beforeinjury.connectingLet the batteryto a charger.warm to
Battery
Reserve
Capacity
(Minutes)
Battery Charge Level
(Percent of Fully Charged)
Charge the battery in  a well–ventilated place to
dissipate gases produced from charging. These
gases are explosive; keep open flame and elec-
trical spark away from the battery. Do not smoke.
Nausea may result if the gases  are inhaled. Un-
plug the charger from the electrical outlet before
connecting or  disconnecting the charger leads
from the battery posts.
75%
50%
25%
0%
80
or less    3.8 hrs
@
7.5 hrs     11.3 hrs     15 hrs
@             @              @
3 amps     3 amps     3 amps
3
amps
81
to 125     5.3 hrs     10.5 hrs   15.8 hrs      21 hrs
@
amps
@             @              @
4 amps     4 amps     4 amps
4
3.
Following the manufacturer’s instructions, con-
nect the charger cables to the battery. Make sure a good
connection is made.
126
170
to
5.5 hrs
@
11 hrs
@
16.5 hrs     22 hrs
@              @
5
amps
5 amps     5 amps     5 amps
171
250
to
5.8 hrs     11.5 hrs    17.3 hrs     23 hrs
4.
instructions.
Charge the battery following the manufacturer’s
@
@             @             @
6 amps     6 amps     6 amps
6
amps
5.
Occasionally check the temperature of_the  battery
_
above
250
6 hrs
12 hrs       18 hrs       24 hrs
@             @             @
amps   10 amps   10 amps   10 amps
@
electrolyte. If the temperature exceeds 125 F (51.6  C)
or the  electrolyte is  violently gassing or  spewing, the
charging rate must be lowered or temporarily stopped.
10
6.
Three hours prior to the end of the charging, mea-
sure the specific gravity of a battery cell once per hour.
The battery is fully charged when the cells are gassing
freely at  a low charging  rate and there  is less  than a
0.003
change in specific  gravity for three consecutive
readings.
Check Interlock System
The purpose of the interlock system is to prevent the en-
gine from cranking or starting unless the traction pedal
is in “NEUTRAL”.
WARNING
The  interlock   switch  is  for   the  operator’s
protection,  so  do  not  disconnect  it.  Check
switch operation daily to assure proper inter-
lock system operation. If  the switch is defec-
tive, replace it  before operating. Whether the
switch is operating properly or not,  replace it
every two years to assure maximum safety. Do
not rely entirely on safety switches – use good
judgement!
1.
of debris and bystanders. Stop engine.
Check interlock operation in a wide open area free
2.
Sit on the  seat. Depress traction  pedal in forward
and reverse directions, while trying to start the engine in
each position. If the engine cranks with the pedal in ei-
ther the forward or reverse position, there may be a mal-
function   in  the   interlock   system.   Repair   problem
immediately. If the engine does not crank, the system is
operating correctly.
Sand Pro 2020/3020/5020
Page 5 – 17
Electrical Systems
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 170 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website