Toro 98957SL Rev B Sand Pro 2020 3020 5020 Service Manual

Procedure for Charge  Relief Valve (R2) and Imple-
ment Relief Valve (R1) Pressure:
5.   Make  sure that traction pedal and lift  control lever
are in neutral and the parking brake is engaged.
1.
perature by operating the machine for approximately 10
minutes.
Make sure hydraulic oil is at normal operating tem-
6.   After installing pressure gauge, start engine and run
at low idle speed. Check for hydraulic leakage and cor-
rect before proceeding with test.
2.
Park machine  on a  level surface with  the attach-
7.   Operate  engine  at full  speed  (3150 +  50  RPM).
ments lowered. Make sure engine is off. Make sure the
parking brake is engaged.
Verify pump hub speed with a phototac.
8.
The  pressure  gauge will  display  system  charge
pressure and should read from 170 to 380 PSI. Record
test results.
CAUTION
9.
If the specification is not met, replace charge relief
valve (R2) (see Hydrostat Service in this Chapter).
An attachment must be installed to the lift cylin-
der for  the performance  of this test  to prevent
personal injury and damage to the machine.
10.
With the engine still running at full speed (3150 + 50
RPM), lower attachment. Hold lift lever in the lower posi-
tion to allow the implement relief valve to activate. Pres-
sure gauge should read from 700 to 1000 PSI. Record
test results.
3.
Read Precautions for Hydraulic Testing.
NOTE:  On the SP 2020/3020, special hydraulic fittings
are required to fit the test gauge into the hydrostat test
port because of  the engine base  plate (see Hydraulic
Test Fittings in the Special Tools section of this Chapter).
11.
If specification is not met, replace implement relief
valve (R1) (see Hydrostat Service in this Chapter).
12.
13.
Shut off engine.
4.
drostat charge test port.
Remove plug and install pressure gauge to the hy-
Disconnect gauge  and fittings  from the  hydrostat
charge test port. Install and tighten plug to test port.
NOTE:  If only implement relief valve (R1) pressure is to
be measured, an alternate pressure gauge location is to
install a T–connector with pressure gauge in series with
the hose from the pump and the T–fitting on the lift valve
(Figure 14).
14.
Make sure hydraulic tank is full (see Check Hydrau-
lic System Fluid).
Sand Pro 2020/3020/5020
Page 4 – 23  Rev. B
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 170 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website