6.
to prevent contamination.
Put caps or plugs on disconnected lines and fittings
3. Remove caps and plugs from disconnected lines
and fittings.
7.
Support manifold to prevent it from falling. Remove
4. Lubricate and install new O--ring(s) on manifold fit-
tings. Connect hydraulic lines to hydraulic manifold fit-
tingsandproperlytightenallconnections(seeHydraulic
Hose and Tube Installation in the General Information
section of this chapter).
three (3) cap screws and lock washers that secure man-
ifold to machine frame. Locate and retrieve three (3)
spacers from between bracket and manifold.
8.
Remove AWD manifold from machine.
5.
(3)
Secure AWD manifold to frame by tightening three
cap screws.
9.
Discard any removed O--rings.
Ifnecessary,removehydraulicfittingsfrommanifold.
6.
oil if necessary.
Check oil level in hydraulic reservoir and add correct
Installation (Fig. 77)
1.
If fittings were removed from AWD manifold, lubri-
7.
Hydraulic System Start--up in this section).
Follow Hydraulic System Start--up procedures (see
cate and place new O--rings tofittings.Installfittingsinto
manifold (see Hydraulic Fitting Installation in the Gener-
al Information section of this chapter).
2.
bracket. Install three (3) lock washers and cap screws
but do not fully tighten screws.
Position manifold and three (3) spacers to frame
Groundsmaster 4300--D
Page 4 -- 87
Hydraulic System
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 4300 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |