Toro 10178SL Service Manual Groundsmaster 4300 D Preface Publication

Indicator Lights
Glow Plug Indicator Light
3.  Apply 12 VDC to terminals 1A and 2A (Fig. 20).
4.  Ground terminals 1B and 2B (Fig. 20).
The glow plug indicator light should come on when the
ignitionswitchisplacedintheRUNpositionpriortoplac-
ing the ignition switch in START. The light should stay lit
for  approximately six  (6)  seconds  while the  ignition
switch is  left in  the RUN position.  The indicator  light
should also be illuminated when the ignition switch is in
the START position.
5.
Both indicator lights should illuminate.
6.
Connect wire harness electrical connector to the in-
dicator light.
7.
Install control  arm cover  to machine  (see Control
Arm Assembly  in the Service  and Repairs section  of
Chapter 6 -- Chassis).
High Temperature Warning Light
If  the   engine  coolant  temperature   reaches  221oF
(105
oC) (approximate), the  high temperature warning
light should come on.
2
3
NOTE:  When machine is in mow operation, high cool-
ant temperature will cause the cutting decks to shut off
in addition to warning light illumination.
1
4
Engine Oil Pressure Light
Figure 19
The engine oil pressure light should come on when the
ignition switch is in the RUN position with the engine not
running. Also, it should illuminate with the engine  run-
ning if the engine oil pressure drops to an unsafe level.
1.
2.
Glow plug indicator
High temp warning
3.
4.
Engine oil pressure
Charge indicator
5
6
Totesttheoilpressurelightandcircuitwiring,groundthe
wire attached to oil pressure switch located on the en-
gine near the oil filter. Turn ignition  switch to the RUN
position;theengineoilpressurelightshouldcome     onin-
dicating correct operation of the indicator light and cir-
cuit wiring.
2
3
Charge Indicator Light
1
4
Thechargeindicatorlightshouldcomeonwhentheigni-
tionswitchisintheRUNpositionwiththeenginenotrun-
ning.  Also,  it  should  illuminate   with  an  improperly
operating charging circuit while the engine is running.
1
2
B (--)
B (--)
1A (+)
2A (+)
Testing Indicator Lights
If testing of the indicator lights is necessary:
1.
tor light and harness connectors (see Control Arm Dis-
assembly in the Service and Repairs section of Chapter
Remove control arm covers to gain access to indica-
Figure 20
6
-- Chassis).
1.
2.
3.
Glow plug indicator
High temp warning
Engine oil pressure
4.
5.
6.
Charge indicator
Indicator light front
2.
Locate the indicator lightto betested anddisconnect
Indicator light back
the wire harness electrical connector from the light.
Groundsmaster 4300--D
Page 5 -- 23
Electrical System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 255 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website