Toro 10178SL Service Manual Groundsmaster 4300 D Preface Publication

The steering relief valve (R10) pressure test should be
performed to make  sure that the steering circuit  relief
pressure is correct.
12.If specification  is not met, inspect  steering control
valve (see Steering Control Valve Service in the Service
and Repairs section of this chapter).
Procedure for Steering Relief Valve Pressure Test:
13.After testing is completed, make sure that engine is
stopped, then relieve  hydraulic system pressure  (see
Relieving Hydraulic System Pressure in the General In-
formation section  of this chapter).  Remove tee  fitting
and pressure gauge from hydraulic hose and  steering
cylinder. Connect hydraulic hose to steering cylinder fit-
ting.
1.
perature  by  operating  the  machine  under  load  for
approximately ten (10) minutes.
Make sure hydraulic oil is at normal operating tem-
2.
decks lowered and PTO switch off. Make sure engine is
off. Apply the parking brake.
Park machine  on  a level  surface with  the cutting
3.
tion.
Read Precautions For Hydraulic Testing in this sec-
1
CAUTION
Before opening hydraulic system, operate all hy-
draulic controls to relieve system pressure and
avoid injury from pressurized hydraulic oil. See
Relieving Hydraulic System Pressure in the Gen-
eral Information section of this chapter.
2
4.
at the rod end of the steering cylinder (Fig. 60).
Thoroughlycleantheareaaroundthehydraulichose
Figure 60
1.
Steering cylinder
2.
Rod end fitting
5.
Remove hydraulic hose  from the fitting on  the rod
end of the steering cylinder.
6.
lic hose and the steering cylinder fitting. Install a 5000
PSI (350 bar) pressure gauge to the tee fitting.
Installateefittingbetweenthedisconnectedhydrau-
7.
at idle speed. Check for any hydraulic leakage from test
connections and correct before proceeding with test.
After installing pressure gauge, start engine and run
8.
Move throttle to full speed (3200 RPM).
IMPORTANT: Hold steering  wheel at full lock  only
long  enough  to get  a  system  pressure  reading.
Holding the steering wheel against the stop for an
extended period may damage the  steering control
valve.
9.
steering wheel for a left hand turn (counter--clockwise)
and holding.
Watch pressure  gauge carefully  while turning  the
10.System
pressure should be approximately 1000 PSI
bar) as the relief valve lifts. Return steering wheel to
the neutral position.
(70
11.
Shut off engine. Record test results.
Groundsmaster 4300--D
Page 4 -- 57
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 255 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website