Retrieving Fault Codes
Faultcodesdisplayedbythediagnosticlightaretwodig-
it numbers with no digit higher than five (5). Fault codes
are listed in the chart below. There will be a one (1) sec-
ond pause between the first and second digit of a code.
Up to three (3) fault codes retained in controller memory
will be displayed by the diagnostic light in order from the
most recent fault to the oldest fault. If there are multiple
faults in controller memory, there will be a three (3) sec-
ond pause between codes. The fault codes will continu-
ally repeat after a five (5) second pause until the ignition
key is turned off.
All machine fault codes are retained in the TEC control-
ler memory. The three (3) most recent fault codes that
have occurred within the last forty (40) hours of opera-
tion can be retrieved using the diagnostic light. To re-
trieve these fault codes from the controller memory,
perform the following switch sequence:
1.
pedalinneutral,parkingbrakereleasedandPTOswitch
in the OFF position.
Operator seat should be UNOCCUPIED, traction
If there are no faults that have occurred within the last
forty (40) hours of operation, the diagnostic light will
flashcontinuously afterperforming theabove switch se-
quence.
2.
tion.
Place mow speed limiter in the TRANSPORT posi-
3.
4.
5.
Move and hold joystick in the RAISE position.
Ifafaultcodeisnotretrieved fromthecontrollermemory
within forty (40) hours of machine operating time, the
fault cannot be retrieved from controller memory using
this procedure. If necessary, contact your Toro distribu-
tor to retrieve older fault codes.
Turn ignition switch to the RUN position.
Monitor the diagnostic light for fault code(s).
NOTE: Once the diagnostic light begins to display fault
codes, the joystick can be released.
Fault Code (Lamp Flashes)
Fault Description
1
1
1
1
-- 1
-- 2
-- 3
-- 4
High engine temp warning occurred (PTO was shutdown by controller)
High engine temp shutdown occurred (engine was shutdown by controller)
Low engine oil pressure occurred
Engine alternator fault occurred
Clearing Fault Codes
2. Operator seat should remain UNOCCUPIED.
After fault codes have been retrieved, clearing of those
faults can be completed using the following switch se-
quence:
3. Move mow speed limiter to the MOW position.
4.
5.
Move joystick to the RAISE position.
Monitor the diagnostic light for continuous flashing
indicating that all faults have been cleared from the con-
troller memory.
1.
Place machine switches in fault retrieval (see
above). The diagnostic light should be displaying the
fault codes.
Groundsmaster 4300--D
Page 5 -- 7
Electrical System
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 4300 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)