Toro 10178SL Service Manual Groundsmaster 4300 D Preface Publication

Hydraulic System Start--up
NOTE:  When initially starting the hydraulic system with
new or rebuilt components such as pumps, wheel mo-
tors or lift cylinders, it is important that this start--up pro-
cedure be used. This procedure reduces the chance of
damaging the system or its components from not purg-
ing the system of air.
7.  Make sure traction pedal is in neutral and the PTO
switch is OFF. Turn ignition key switch to start; engage
starter for ten (10) seconds to prime hydraulic pumps.
Wait fifteen (15) seconds  to allow the starter motor to
cool and then repeat cranking procedure again.
8.
Connect wire  harness electrical  connector to  fuel
1.
After the hydraulic system  components have been
stop solenoid to allow engine to start.
properly installed and if the traction pump was rebuilt or
replaced, make sure traction pump housing is  at least
half full of clean hydraulic oil.
9.
Make sure traction pedal is in neutral and the PTO
switch is OFF. Start  engine and run it at low idle.  The
charge pumpshould pick upoilandfillthe  hydraulic sys-
tem. If there is no indication of fill in thirty (30) seconds,
stop the engine and determine the cause.
2.
cured tightly.
Makesureallhydraulicconnectionsandlinesarese-
3.
Drain, flush and refill hydraulic system and change
10.If the traction pump was replaced or rebuilt, run the
traction unit so the wheels turn slowly for ten (10) minu-
tes.
hydraulic oil filters if  component failure was severe or
system is contaminated (see Flush Hydraulic System in
this section).
11.
Operate the traction unit (including steering and cut-
4.
if necessary.
Make sure hydraulic reservoir is full. Add correct oil
ting deck  lift/lower) by  gradually increasing  the work
load to full over a ten (10) minute period.
5.
or broken parts.
Check control linkage for proper adjustment, binding
12.Stop the machine. Check oil level in hydraulic reser-
voir and add  correct oil if necessary. Check  hydraulic
components for  leaks and tighten  any loose connec-
tions.
6.
the engine fuel stop solenoid to prevent the engine from
starting.
Disconnect wire harness  electrical connector from
Groundsmaster 4300--D
Page 4 -- 63
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 255 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website