12.Install
section).
air cleaner (see Air Cleaner Installation in this
CAUTION
IMPORTANT: Make sure that clutch pulley and
P.T.O. pulley are aligned during P.T.O. shaft installa-
tion.
One person should operate lift or hoist while the
other person guides the engine into the ma-
chine.
13.Install
P.T.O. shaft to machine (see P.T.O. Shaft
Installation in Service and Repairs section of Chapter 9
P.T.O. System).
IMPORTANT: Make sure not to damage the engine,
fuel hoses, hydraulic lines, electrical harness or
other parts while installing the engine.
−
14.Position
fan shroud to radiator. Make sure that a
minimum of .250” (6.4 mm) clearance exists at all points
between shroud and fan. Secure fan shroud to radiator
with four (4) cap screws, flat washers and lock nuts.
C. Lower engine to the machine frame. Make sure
that the engine bracket holes are aligned with the
holes in the engine shock mounts.
15.Install
shroud (Fig. 13). Install overflow hose to radiator fill
opening and secure with hose clamp.
coolant reservoir to bracket on radiator fan
D. Secure engine to the engine mounts.
7.
Install clevis pin and cotter pin to secure hood cable
to muffler bracket.
16.Add
coolant to radiator (see Traction Unit Operator’s
Manual).
8.
Connect transmission drive shaft to engine pulley
(see Hydraulic Transmission Drive Shaft Installation in
the Service and Repairs section of Chapter 5 − Hydrau-
lic System).
NOTE: Make sure to attach negative battery cable as
battery base is installed.
17.Position
cap screws and flange nuts (Fig. 12).
battery base to brackets and secure with
9.
components.
Reconnect all wire harness connectors to engine
18.Install
Service and Repairs section of Chapter 6 − Electrical
System).
battery to machine (see Battery Service in the
10.Remove
bly. Connect hoses to the engine.
plugs installed in hoses during disassem-
A. Connect fuel hose to the carburetor inlet fitting.
Secure with hose clamp.
19.Check
Manual).
engine oil level (see Traction Unit Operator’s
B. Connect upper and lower radiator hoses to the
engine. Secure with hose clamps.
20.Connect
cables to the battery.
positive (+) and then negative (−) battery
11.
Position throttle and choke cables to engine gover-
21.Close
hood (see Traction Unit Operator’s Manual).
nor levers (Fig. 14). Secure cables to governor bracket
with cable clamp and screw. Adjust cables (see Adjust
Throttle Control and Adjust Choke Control in the Adjust-
ments section of this chapter).
Groundsmaster 3320
Page 3 − 15
Gasoline Engine
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 3280 D, Toro Groundsmaster 3320 |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)