Toro 05138SL Rev A Service Manual Groundsmaster 3280 D 3320 Preface Publication

6.
Anytime the machine is parked (short or long term),
7.  Do not park on slopes unless wheels are chocked or
blocked.
the cutting deck (or implement) should be lowered to the
ground. This relieves  pressure from the lift circuit  and
eliminates the risk of the cutting deck (or implement) ac-
cidentally lowering to the ground.
Maintenance and Service
1.
ting deck (or implement), stop engine, set parking brake
and remove key from the switch.
Before servicing or making adjustments, lower cut-
11.Do not overspeed the engine by changing governor
setting. To assure safety and accuracy, check maximum
engine speed with a tachometer.
2.
keeping all nuts, bolts and screws tight.
Make sure machine is in safe operating condition by
12.Shut engine off before checking or adding oil to the
crankcase.
3.
where there is an open flame, such as near a water heat-
er or furnace.
Never  store the  machine  or fuel  container  inside
13.Disconnect  battery before  servicing  the machine.
Disconnect  negative  battery  cable first  and  positive
cable last. If battery voltage is required for troubleshoot-
ing or test procedures, temporarily connect the battery.
Reconnect positive cable first and negative cable last.
4.
Make sure all hydraulic line connectors are tight, and
all hydraulic hoses and lines are in good  condition be-
fore applying pressure to the hydraulic system.
14.Battery  acid  is  poisonous and  can  cause  burns.
Avoid contact with skin, eyes and clothing. Protect your
face, eyes and clothing when working with a battery.
5.
Keep body and hands away from pin hole leaks in hy-
draulic lines that eject high pressure hydraulic fluid. Use
cardboard or  paper to  find hydraulic  leaks. Hydraulic
fluid escaping under  pressure can penetrate skin  and
cause injury.  Fluid  accidentally injected  into  the skin
must be surgically removed within a few hours by a doc-
tor familiar with this form of injury or gangrene may re-
sult.
15.Battery gases can explode. Keep cigarettes, sparks
and flames away from the battery.
16.If
welding on the machine is necessary, disconnect
the negative battery cable to prevent electrical system
damage.
17.At
the time of manufacture, the machine conformed
6.
Before disconnecting or performing any work on the
to the safety standards for riding mowers. To assure op-
timum performance and continued safety certification of
the machine, use genuine Toro replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with  the safety  standards,  and the  warranty may  be
voided.
hydraulic system, all pressure in the system must be re-
lieved by lowering the cutting deck (or implement) to the
ground, stopping the engine and then using all of the hy-
draulic controls (depressing the traction  pedal, turning
the steering wheel and moving the lift/lower lever to both
raise and lower).
7.
sired, contact an Authorized Toro Distributor.
If major repairs are ever needed or assistance is de-
18.When
changing  attachments,  tires  or performing
other  service,  use  correct blocks,  hoists  and  jacks.
Make sure machine is parked on a solid level floor such
as a concrete floor. Prior to raising the machine, remove
any attachments  that may interfere  with the safe  and
proper raising of  the machine. Always  chock or block
wheels. Use jack stands or solid wood blocks to support
the raised machine. If the machine is not properly sup-
ported by blocks or jack stands, the machine may move
or fall, which may result in personal injury (see Jacking
Instructions in this section).
8.
deck. Wear gloves and use caution when servicing it.
Use  care when  checking  or servicing  the  cutting
9.
free of excessive grease, grass, leaves and dirt. Clean
protective screen on machine frequently.
To reduce  potential fire  hazard, keep  engine area
10.If
engine must be running to perform maintenance or
to make an adjustment, keep hands, feet, clothing and
other parts of the body away from the cutting deck and
other moving parts. Keep bystanders away.
Groundsmaster 3280−D/3320
Page 1 − 3
Safety
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 260 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website