Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the ignition switch connector before
doing a continuity check).
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms setting), make sure
that power to the circuit has been disconnected.
NOTE: For engine component testing information, see
the Kubota Workshop Manual, Diesel Engine, V2003−T
Series at the end of Chapter 3 − Kubota Diesel Engine.
Ignition Switch
The ignition (key) switch has three positions (OFF, ON/
PREHEAT, and START). The terminals are marked as
shown. The circuit wiring of the ignition switch is shown
in the chart. With the use of a multimeter (ohms setting),
the switch functions may be tested to determine whether
continuity exists between the various terminals for each
position. Verify continuity between switch terminals.
A
B
Y
S
X
POSITION
OFF
CIRCUIT
NONE
I
ON / PREHEAT
START
B + I + A, X + Y
B + I + S
Figure 8
2
1
4
3
Figure 9
1.
2.
Key
Hex nut
3.
4.
Lock washer
Ignition switch
OFF
45°
ON / PREHEAT
45°
START
Figure 10
Groundsmaster 4100−D
Electrical System
Page 5 − 10
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Groundsmaster 4100 D |
Download File |
|
Document Type | Catalog |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |