Toro 03116SL Rev E Service Manual Groundsmaster 4100 D Preface Publication

Removal (Fig 43)
Park  machine  on  a  level  surface,  lower  cutting
decks, stop engine, engage parking brake, and remove
key from the ignition switch.
Installation (Fig 43)
1.
1.  Lubricate new o--rings  with clean hydraulic oil and
position on pump.
2.
Slide coupler onto the piston pump output shaft.
2.
to gear pump.
Raise seat and secure it with prop rod to gain access
3.
Position o--rings  and  spacer to  gear pump.  Align
gear teeth and slide gear pump input shaft into coupler.
Secure gear  pump  to piston  pump with  two  (2) cap
screws and washers.
3.
al).
Drain the hydraulic reservoir (see Operator’s Manu-
To prevent contamination of hydraulic system during
4.
pump removal, thoroughly clean exterior of  pump and
fittings.
4.  Remove caps or plugs from  hydraulic lines and fit-
tings. Install hydraulic lines to gear pump.
5.
Replace hydraulic  filter and  fill hydraulic reservoir
5.
Installing Hydraulic System Components at the begin-
ning of the Service and Repairs section of this chapter.
Read the  General Precautions  for Removing  and
with new hydraulic oil.
6.
Disconnect engine run solenoid electrical connector
to prevent  engine  from starting.  Prime the  hydraulic
pumpbyturningtheignitionkeyswitchtostartandcrank
the engine for 15 seconds. Wait 15 seconds and repeat
cranking procedure again.
6.
caps or plugs on open hydraulic lines and fittings. Label
disconnected hydraulic lines for proper reassembly.
Disconnect hydraulic lines from gear pump and put
7.
ling.
Support gear pump assembly to prevent it from fal-
7.  Connect engine  run solenoid  electrical connector,
start the engine, and check for proper operation.
8.
Removetwo(2)capscrewsandwashersthatsecure
8.  Properly fill hydraulic system (see Charge Hydraulic
System in the Service and Repairs section of this chap-
ter).
gear pump to piston  pump. Remove gear pump, cou-
pler, spacer,and o--rings from machine through the seat
opening.
9.
Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level.
Groundsmaster 4100--D
Page 4 -- 53
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 258 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website