Toro 03116SL Rev E Service Manual Groundsmaster 4100 D Preface Publication

Procedure  for  Lift/Lower  Circuit Relief  Pressure
Test
2
1
NOTE:  Before attempting to check or  adjust lift pres-
sure, make sure  that counterbalance pressure is  cor-
rectly adjusted.
1.
perature by operating the machine for approximately 10
minutes. Make sure the hydraulic tank is full.
Make sure hydraulic oil is at normal operating tem-
2.
decks lowered and off. Make sure engine is off and the
parking brake is engaged. Raise seat.
Park machine  on  a level  surface with  the cutting
Figure 32
2.
CAUTION
1.
Lift circuit port
Hydraulic reservoir cap
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS, and Pre-
cautions for Hydraulic Testing at the  beginning
of this section.
2
3
4
5
3.
Raise seat  to gain access  to hydraulic test  fitting.
Connect a 5,000 PSI gauge to lift circuit test port (Fig.
Route gauge hose to allow seat  to be safely low-
32).
ered.
4.
After installing pressure gauge, start engine and run
1
at idle speed. Check for hydraulic leakage and correct
before proceeding with test.
5.
(2730
Sit on the seat and operate the engine at full speed
+ 30 RPM).
6.
While sitting on the seat, pull lift lever back to raise
the cutting decks. Momentarily hold the lever with the lift
cylinder fully retracted (decks fully raised) while looking
at the gauge.
Figure 33
1.
2.
3.
Control valve assembly
Relief valve assembly
Washers
4.
5.
Spring
Poppet
GAUGE READING TO BE 2500 to 2550 PSI.
7.
8.
valve in lift  control valve by rotating  counterclockwise
(Figure 33). If pressure is too low, check for restriction
in pump intake line.  Check the lift cylinder for internal
leakage. If cylinder is not leaking, adjust the relief valve
by rotating clockwise. If pressure is still too low, pump or
lift cylinder(s) should be suspected of wear, damage or
inefficiency.
Record test results.
Stop the engine. If pressure is too high, adjust relief
9.
Disconnect pressure gauge from test port.
Groundsmaster 4100--D
Page 4 -- 39
Hydraulic System
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 258 pages
Document TypeCatalog
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website