Toro 07150SL Groundsmaster 7200 7210 Service Manual

Component Testing
For accurate resistance and/or continuity checks, elec-
trically disconnect the component being tested from the
circuit (e.g. unplug the ignition switch connector before
doing a continuity check on the switch).
CAUTION
When testing electrical components for continu-
ity with a multimeter (ohms  setting), make sure
that power to the circuit has been disconnected.
NOTE:  For engine component testing information, see
the Kubota  Workshop Manual, Diesel  Engine, 05 Se-
ries.
Ignition Switch
The ignition (key) switch has three positions: OFF, ON/
PREHEAT and START (Fig. 6). The switch terminals are
identified as shown in Figure 7.
OFF
45°
ON/PREHEAT
The Standard Control Module (SCM) monitors  the op-
eration of the ignition switch. When the ignition switch is
in the ON position, the SCM power input LED should be
illuminated.
45
°
START
Testing
1.
Before disconnecting the ignition switch for testing,
the switch and  its circuit wiring  should be tested as  a
SCM input (see  Standard Control Module  in this sec-
tion).
Figure 6
2.
wiring are functioning correctly, no further switch testing
If the SCM verifies that the ignition switch and circuit
A
is necessary.
B
3.
cuit  wiring are  not functioning  correctly,  test ignition
If the SCM determines that the ignition switch and cir-
Y
S
switch as follows:
A.  Make sure ignition switch is in the OFF position.
Disconnect  wire  harness  connector  from  ignition
switch.
I
X
Figure 7
B.  The circuitry of the ignition switch is shown in the
chart in the right column. With the use of a multimeter
(ohms setting), the switch functions may be tested to
determine  whether  continuity  exists between  the
various  terminals for  each  switch  position.  Verify
continuity between switch terminals.
SWITCH
NORMAL
OTHER
POSITION
CIRCUITS
CIRCUITS
OFF
ON
NONE
B + A + I
B + S + I
NONE
X + Y
C. Replace ignition switch if necessary.
START
NONE
D. If  the ignition switch tests correctly and a  circuit
problem still exists, check wire harness (see Electri-
cal Schematics and Circuit Drawings in Chapter 8 –
Foldout Diagrams).
E.  Connect machine wire harness connector to igni-
tion switch.
Electrical System
Page 5 – 10
Groundsmaster 7200/7210
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 226 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

One thought on “Toro 07150SL Groundsmaster 7200 7210 Service Manual

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website