Indicator Lights
Charge Indicator Light
The charge indicator light should come on when the igni-
tion switch is in the ON position with the engine not run-
ning. Also, it should illuminate with an improperly
operating charging circuit while the engine is running.
2
3
Engine Oil Pressure Light
4
The engine oil pressure light should come on when the
ignition switch is in the ON position with the engine not
running. Also, it should illuminate with the engine run-
ning if the engine oil pressure drops to an unsafe level.
1
IMPORTANT: If the oil pressure indicator light is il-
luminated with the engine running, shut off the en-
gine immediately.
Figure 8
1.
2.
Glow plug indicator light
High temp warning light
3.
4.
Oil pressure light
To test the oil pressure light and circuit wiring, ground the
green wire attached to oil pressure switch located on the
engine near the oil filter. Turn ignition switch to the ON
position; the engine oil pressure light should come on in-
dicating correct operation of the indicator light and cir-
cuit wiring.
Charge indicator light
5
2
3
4
High Temperature Warning Light
If the engine coolant temperature reaches 220oF
(105
oC) (approximate), the high temperature warning
light will come on.
6
1
NOTE: The PTO will disengage if the engine coolant
temperature reaches 220oF (105oC) (approximate).
To test the high temperature warning light and circuit wir-
ing, turn ignition switch to the ON position and ground
the yellow wire attached to high temperature warning
switch located on the engine water pump housing (see
High Temperature Warning Switch in this Chapter). The
high temperature warning light should illuminate.
1
B (–)
1A (+)
2A (+)
2B (–)
Glow Plug Indicator Light
Figure 9
1.
2.
3.
Glow plug indicator
High temperature
Engine oil pressure
4.
5.
6.
Charge indicator
Indicator light front
Indicator light back
The glow plug light should come on when the ignition
switch is placed in the ON position prior to placing the
ignition switch in START. The light should stay lit for
approximately 10 seconds while the ignition switch is left
in the ON position.
Testing Indicator Lights
1.
2.
3.
Apply 12 VDC to terminals 1A and 2A (Fig. 9).
Ground terminals 1B and 2B (Fig. 9).
Both indicator lights should illuminate.
Groundsmaster 7200/7210
Page 5 – 11
Electrical System
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Groundsmaster 7200, Toro Groundsmaster 7210 |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
My mower is a TORO 7210.
Start fuse defection. Why ?