Change Hydraulic Oil and Filter
Changehydraulicfilterinitiallyafterthefirst50operating
hours, thereafter change hydraulic oil and filter after ev-
ery 800 hours. Contaminated oil looks milky or black
when compared to clean oil. If oil becomes contami-
nated, flush hydraulic system (see Flush Hydraulic Sys-
tem).
HOSE
Note:
If oil is not going to be drained, disconnect and
plug hydraulic line going to filter.
1.
pan under filter and remove filter. Allow hydraulic oil to
drain completely.
Clean area around filter mounting area. Place drain
FILTER
2.
Fillreplacementfilterwithhydraulicfluid(seeCheck
Figure 37
Hydraulic System Fluid), lubricate the sealing gasket
and hand turn until gasket contacts filter head. Then
tighten 3/4 turn further. Filter should now be sealed.
3.
lons (8.1 gallons if machine is equipped with leak detec-
tor) of hydraulic oil (see Check Hydraulic System Fluid).
Fill hydraulic reservoir with approximately 5.5 gal-
4.
circulate the fluid and remove any air trapped in the sys-
tem. Stop engine and recheck fluid level.
Start engine and run it at idle for 3 to 5 minutes to
5.
Dispose of hydraulic fluid properly.
Greensmaster 3250--D
Page 4 -- 65
Hydraulic System (Rev. I)
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Greensmaster 3250 D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |