Toro 00062SL Rev I Greensmaster 3250 D Service Manual

4.
to rotate free of the springs.
Install ring over the sleeve. Make sure ring is able
OUTER RACE
NEEDLE BEARING
INNER RACE
5.
6.
Insert cross pin into the spool and sleeve (Fig. 69).
Install bearing assembly onto the spool and sleeve
(Fig. 72).
7.
ly. Install ring carefully into the inner bore of the housing
so that they fit snuggly in place (Fig. 73 and 74).
Coat new O--ring/kin--ring lightly with petroleum jel-
CHAMFERED
SIDE
SPOOL
Note:
The cross pin should be held  horizontal when
SLEEVE
inserting the spool and sleeve into the housing.
Figure 72
Note:
The  clearance  between the  sleeve  and  the
housing bore is very tight. The heat from one’s hand can
cause the sleeve to expand enough so that it will not fit
into the housing. Refrigerate thespool/sleeve assembly
prior to installation. Insulate assembly from one’s hand
when installing.
O--RING/KIN--RING
INNER
BORE
8.
using a light turning motion. Be careful not to  damage
the O--ring/kin--ring.
Guidespoolandsleeveintothehousingcarefullyby
DUST SEAL
HOUSING BOTTOM
9.
Placeballintothelargestthreadedhole.Secureball
Figure 73
into hole by threading in the bushing. Make sure the top
of the bushing lies just bellow the surface of the housing
(Fig. 74).
10.
O--ring into groove on housing surface.
Coat new O--ring lightly with petroleum jelly. Install
THREADED
BUSHING
11.
Mount distributor  plate  onto housing.  Make sure
channel holes in plate match the hole of the housing.
12.
Insert cardan  shaft carefully  into the  bore of  the
housing. Make sure shaft slot is parallel with the surface
of the connection flange.
13.
Install O--rings into grooves  on rim of gear wheel  set.
Place rim onto distributor plate.
Coat both new O--rings lightly with petroleum jelly.
O--RING/
KIN--RING
Figure 74
IMPORTANT: The  gear wheel  fits into  the  cardan
shaft from one direction only. The tooth base on the
wheel should be positioned in relation to the shaft
slot (Fig. 75).
14.
Fit gear wheel onto cardan  shaft and into the rim.
Make sure  holes in rim  are aligned  with holes in  the
housing.
15.
Install end cover onto rim of gear wheel.
Figure 75
Greensmaster 3250--D
Hydraulic System (Rev. I)
Page 4 -- 106
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 308 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website