Front Roller Brush/Scraper Removal and Installation
Removal
1.
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2.
Loosen and remove cap screws securing each end
of the roller shaft to the front roller brackets.
3.
Remove capscrews and locknuts securing the left
front roller bracket to the side plate.
4.
5.
Remove front roller from both roller brackets
Slide clamp block off each end of the roller shaft.
Note:
If the front roller brush/scraper is not to be rein-
stalled, proceed to steps 6 and 7.
2
1
6.
bracket and fasteners previously removed.
Reinstall roller to cutting unit with left front roller
3
7.
Level front roller and set Height−of−Cut (see Adjust
5
4
and Level Front Roller to Reel, and Adjust Height−of−
Cut).
6
Figure 62
1.
2.
3.
Front roller bracket
Front roller
Clamp block
4.
5.
6.
Scraper rod
Socket head screw
Jam nut
Installation
1.
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
7.
each clamp block.
Partially thread a socket head screw into the front of
2.
shaft to the front roller brackets.
Loosen caps crews securing each end of the roller
Note:
scraper to the rear of roller and with the brush down-
ward.
Brush/scraper must be positioned with the
3.
Remove cap screws and locknuts securing the left
front roller bracket to the side plate.
8.
Reinstall roller and brush/scraper to the cutting unit
with the front roller bracket and fasteners previously re-
moved.
4.
Position clamp blocks on roller shaft so the slot is up and
the threaded portion of hole is toward the rear.
Slide clamp block onto each end of the roller shaft.
9.
Level front roller and set Height−of−Cut. Refer to
Cutting Unit Operator’s Manual for adjustment proce-
dures.
5.
Thread nut onto each scraper rod.
6.
Loosely secure scraper rods to clamp blocks with a nut.
Insert both scraper rods through each clamp block.
10.
Brush/Scraper).
Adjust brush/scraper (see Adjust Front Roller
Greensmaster 3250−D
Page 7 − 37
SPA and 4−Bolt Cutting Units (Rev. A)
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Greensmaster 3250 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)