Adjust and Level Front Roller to Reel
1.
remove reel motor from the cutting unit and cutting unit
from lift arm (see Cutting Unit Removal and Installation).
If the cutting unit is not removed from the machine,
1
3
Note:
Make sure leveling plate covers the full length
of reel blades. Three blades must contact the plate.
2.
known flat and level surface.
Position cutting unit on a cutting leveling plate or a
2
3.
Position a 1/4−inch or thicker bar stock under the
reel blades and against the front face of the bedknife.
Figure 26
Note:
hole (see Attitude Adjustment).
Make sure both front brackets are in the same
1.
2.
Lock nuts
Right front roller bracket
3.
Eccentric bolt
4.
et.
Loosen both lock nuts securing the right front brack-
Note:
If additional adjustment is required, replace
shoulder bolt on the left front bracket with another ec-
centric bolt (see cutting unit parts catalog for current part
number). Make sure both front roller brackets are in the
same hole.
Note:
The right front bracket is secured to the frame
with an eccentric bolt, while the left front bracket is se-
cured with a shoulder bolt. The eccentric bolt has an off-
set, which when rotated, acts as an eccentric (cam) to
raise or lower the roller. On the bolt head there is an
identification dot which denotes the offset of the bolt.
The dot indicates in which direction the right end of roller
moves when bolt is turned.
6.
Verify roller is level. Insert a piece of paper or 0.003
inch (0.076 mm) feeler gauge under each end of the roll-
er.
7.
When the roller is level, tighten lock nuts securely.
5.
While holding reel securely on plate and maintain-
ing pressure on front roller, rotate upper right roller
mounting bolt. This mounting bolt has an offset, which
when rotated, acts as an eccentric (cam) to raise or low-
er the roller. On the bolt head there is an I.D. dot which
denotes the offset of the bolt. The dot indicates in which
direction right end of roller moves when bolt is turned.
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 12
Greensmaster 3250−D
| Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
|---|---|
| Tags | Toro Greensmaster 3250 D |
| Download File |
|
| Document Type | Service Manual |
| Language | English |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)