Toro 00062SL Rev I Greensmaster 3250 D Service Manual

Troubleshooting
There are a number of factors that can contribute to un-
satisfactory quality  of cut, some  of which may  be turf
conditions. Turf  conditions such  as excessive  thatch,
“sponginess” or  attempting to  cut off  too much grass
height may  not always be  overcome by adjusting  the
cutting unit. It is  important to remember that the lower
the height−of−cut,  the more critical  these factors are.
See Adjustments and Service and Repairs sections for
detailed adjustments and repair information.
For additional information regarding cutting unit trouble-
shooting, see Aftercut Appearance Troubleshooting Aid
(Toro part no. 00076SL).
Factors That Can Affect Quality of Cut
Factor
Possible Problem/Correction
Tire pressure
Check pressure of all tires. Pressure must be equal on
both front tires. Adjust pressure as necessary.
See General section in Chapter 6 − Wheels and
Brakes.
Governed engine speed
Reel bearing condition
Check maximum governed engine speed. Adjust
engine to specifications if necessary.
See Adjustments section in Chapter 3 − Engine.
Check bearings for wear and replace if necessary.
Make sure bearing housings are secured properly.
Keep bearings well lubricated.
See Reel and Bearing Removal and Installation.
Reel and bedknife sharpness
A reel and/or bedknife that has rounded cutting edges
or “rifling” (grooved or wavy appearance) cannot be
corrected by tightening the bedknife to reel contact.
Grind reel to remove taper and/or rifling. Grind
bedknife to sharpen and/or remove rifling.
The most common cause of rifling is bedknife to reel
contact that is too tight.
A new bedknife must be ground or backlapped
after installation to the bedbar.
Bedknife to reel adjustment
Check bedknife to reel contact daily. The bedknife
must have light contact across the entire reel. No
contact will dull the cutting edges. Excessive contact
accelerates wear of both edges. Quality of cut is
adversely affected by both conditions (see Bedknife to
Reel Adjustment).
Slightly dull cutting edges may be corrected by
backlapping (see Backlapping).
Excessively dull cutting edges must be corrected by
grinding the reel and bedknife (see Preparing Reel for
Grinding).
Greensmaster 3250−D
Page 7 − 7
SPA and 4−Bolt Cutting Units (Rev. A)
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 308 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website