Toro 00062SL Rev I Greensmaster 3250 D Service Manual

12.
Separate relief valve from the pump plate by remov-
ing both cap screws flat washers, and lock nuts (Fig. 26).
1
13.
Separate hydrostat from the pump plate as follows:
A.  Loosen both set screws securing the hydrostat
shaft to the hub (Fig. 27).
2
CAUTION
Use caution when removing the traction control
mechanism. The extension spring is  under ten-
sion and  may cause personal  injury during  re-
moval.
Figure 26
2.
1.
Relief valve
Cap screw
B.  Remove cap  screw  and flat  washer  securing
pump lever and plate to the trunnion shaft (Fig. 28).
8
C. Remove  cap screws and spacers securing  the
cable support bracket to the pump (Fig. 28).
5
6
D. Disconnect  extension  spring  from  the  spring
bracket. Remove traction control mechanism from
the pump as a complete unit (Fig. 28).
1
2
E.  Remove  both locknuts,  cap  screws,  and  flat
washers securing the hydrostat to the pump plate.
Be careful not to lose the key (Fig. 27).
7
4
F.  Swing hydrostat  out from the machine and  se-
cure to prevent dropping.
3
Figure 27
1.
Set screw
Hydrostat
Hub
5.
6.
7.
8.
Cap screw
Flat washer
Pump plate
Key
14.
ing engine components:
Disconnect electrical connections  from the follow-
2.
3.
4.
Lock nut
A.  The black  (negative)  battery cable  and  black
wire harness ground on the hydrostat end of the en-
gine block.
6
7
1
B.  The red battery cable and red wire with plug on
the starter solenoid. Both gray and  one black wire
from starter terminals.
C. The orange wire on the glow plug bus.
4
D. The  blue/white wires and plug−in  connector to
the ETR solenoid (injection pump).
2
3
5
E.  The yellow/red  wire on the  water temperature
switch.
Figure 28
F.  The white/red wire on the oil pressure switch.
1.
Cap screw & flat washer
Cap screw
5.
6.
7.
Pump
Extension spring
Spring bracket
2.
3.
4.
Spacer
G. Plug−in connector with white and green wires to
the alternator. Also, grey wire with rubber cap.
Cable support bracket
16.
crank shaft pulley for better clearance (Fig. 19).
Separate fan adapter  (2) and fan  (4) from engine
15.
ing the fan deflector (41) to the front engine mount (13)
(Fig. 19).
Remove both hex washer head screws (40) secur-
Greensmaster 3250−D
Page 3 − 19
Engine
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 308 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website