Toro 00062SL Rev I Greensmaster 3250 D Service Manual

Factor
Possible Problem/Correction
Bedknife attitude
Set attitude (angle) as recommended.
See Leveling Front Roller to Reel and Attitude
Adjustments.
Rear roller adjustment
Height−of−cut
Check and adjust as necessary. The rear roller must
be leveled so it is parallel with the reel for proper
height−of−cut setting.
See Height−of−Cut Adjustment.
“Effective” or actual height−of−cut depends on the
cutting unit weight and turf conditions. Effective
height−of−cut will be different from the bench set
height−of−cut.
See Height−of−Cut Adjustment.
Proper bedknife selection for height−of−cut desired
Stability of bedbar
If the bedknife is too thick for effective height−of−cut,
poor quality of cut will result.
Make sure bedbar pivot bolts are seated securely.
Check condition of the bushings in the side plates.
See Bedbar Removal and Installation.
Number of reel blades
Use correct number of blades for clip frequency and
optimum height−of−cut range.
Cutting unit alignment and pull frame ground following     Check pull frames and lift arms for damage, binding, or
bushing wear. Repair if necessary.
Roller condition
Reel speed
Make sure rollers rotate freely. Grease roller as
recommended and repair bearings as necessary.
See Roller Bearing Replacement in Service and
Repairs section.
All reels must rotate at the same speed (within 100
rpm). All cutting units must have equal bedknife to reel,
front roller to reel, attitude, and height−of−cut
adjustments. Check reel speed setting if a
backlap/variable reel speed kit is installed.
See Adjustments in this chapter and Troubleshooting
in Chapter 4 − Hydraulic System.
Traction speed
Check maximum governed engine speed. Adjust
engine to specifications if necessary. See Adjustments
section in Chapter 3 − Engine. Check traction pedal
adjustment.
See Adjusting Transport and Mowing Speed, and
Troubleshooting in Chapter 4 − Hydraulic System.
Cutting Unit drop speed and sequence
Center cutting unit must drop after front cutting units.
See Troubleshooting in Chapter 4 − Hydraulic System.
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 8
Greensmaster 3250−D
Product Specification
CategoriesLawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 308 pages
Document TypeService Manual
LanguageEnglish
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website