Adjust Front Roller Brush/Scraper
1.
Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2.
Loosen socket head screws securing the clamp
blocks to the roller shaft.
Note:
Secure one end of the brush assembly at a time
to simplify the following steps.
3.
Adjust aggressiveness of the brush/scraper as fol-
lows:
A. Bristles touching the adjusting gauge bar gives
you an aggressive setting.
B. Adjusting the brush assembly so it is midway be-
tween the adjusting gauge bar and the cutting edge
of the bedknife will provide a medium setting.
2
1
3
C. Adjusting the brush assembly so it is even with
the cutting edge of the bedknife will provide a light
setting.
5
4
6
4.
to roller shaft.
Tighten socket head screws securing clamp blocks
Figure 35
4.
5.
6.
1.
2.
3.
Front roller bracket
Front roller
Clamp block
Scraper rod
Socket head screw
Jam nut
5.
Adjust jam nuts on each scraper rod until there is a
clearance of approximately 1/32 inch (0.8 mm) between
the scraper and roller. Make sure scraper is parallel to
the roller.
SPA and 4−Bolt Cutting Units (Rev. A)
Page 7 − 16
Greensmaster 3250−D
Product Specification
Categories | Lawn Mower Manual, Sprinkler and Irrigation Manuals, Toro Sprinkler and Irrigation Manuals |
---|---|
Tags | Toro Greensmaster 3250 D |
Download File |
|
Document Type | Service Manual |
Language | English |
Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
Document File Type | |
Publisher | toro.com |
Wikipedia's Page | Toro Company |
Copyright | Attribution Non-commercial |